Remove/install detachable parts for replacing outside sliding door entrance

AR60.00-D-0059TS

Remove/install detachable parts for replacing outside sliding door entrance

14.04.2020

Model

907.6/7, 910.6

with code T16 (Sliding door right)

Model

907.6/7, 910.6

with code T19 (Sliding door left)

Modification notes

09.12.2019

Method extended

Operation step 20

Shown on model 910.631 with code D03 (Roof and rear-end doors, high version) and code T16 (Sliding door, right), right side of vehicle

1

Sliding door entrance

Shown on model 907 except code EL9 (2-way front and rear speaker system) and except code FY2 (Double lock) and except code T51 (Electric closing assist for left sliding door) and except code T56 (Electrical actuation for left sliding door), left side of vehicle

2

Fuel filler flap

3

Filler neck

4

Lower guide rail

6

Protective strip

7

Frame seal

8

Frame seal

9

Lock striker

10

Contact plate

11

Guide bearing

12

Bolts

13

Bolts

Shown on model 907, right side of vehicle

17

Electrical wiring harness

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.Typ 910.6 mit Motor 780.703

AS00.00-Z-0035-01A

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment

Typ 910.6 mit Motor 780.703

AH00.00-Z-0300-01A

Topical note

Notes on battery

AH54.10-P-0001-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Remove respective sliding door.

Model 907.6/7 except code T55 (electrical actuation for the right sliding door) except code T56 (electrical actuation for left sliding door), model 910.6

AR72.16-D-1260TS

Model 907.6/7 with code T55 (electrical actuation for right sliding door) or with code T56 (electrical actuation for left sliding door)

AR72.16-D-1260TSB

2

Remove respective lower guide rail (4).

Model 907.6/7

AR72.16-D-7816TS

3

Remove fuel filler flap (2).

If left side of vehicle is damaged.

Model 910.6 with engine 651, model 907.6/7

AR88.60-D-6023TS

4

Remove filler neck (3).

If left side of vehicle is damaged.

Model 907.6 with engine 654.9, Models 907.6/7 with engines 642, 651, Model 910.6 with engine 651

AR47.10-D-7541TS

Model 907.6/7 with engine 274

AR47.10-D-7541TSC

5

Remove upper trim from partition.

Model 907.6, 910.6 with code D50 (full-width partition wall) with code VA3 (load compartment interior trim up to roof height, washable), model 907.6, 910.6 with code D51 (full-width partition wall with 1 window) with code VA3 (load compartment interior trim up to roof height, washable), model 907.6, 910.6 with code D64 (partition with sliding door) with code VA3 (load compartment interior trim up to roof height, washable)

AR68.30-D-1407TS

6

Remove lower trim from partition.

Model 907.6, 910.6 with code D50 (full-width partition wall) with code VA3 (load compartment interior trim up to roof height, washable), model 907.6, 910.6 with code D51 (full-width partition wall with 1 window) with code VA3 (load compartment interior trim up to roof height, washable), model 907.6, 910.6 with code D64 (partition with sliding door) with code VA3 (load compartment interior trim up to roof height, washable)

AR68.30-D-1408TS

7

Remove trim from respective sliding door entrance step module.

Model 907.6 except code V39 (Plastic floor for people mover) except code VK8 (Plastic floor covering)

AR68.30-D-0018TSB

Model 907.6 with code V39 (plastic floor for people mover) or with code VK8 (plastic floor covering), model 907.7

AR68.30-D-0018TSR

8

Remove front partition.

Model 907.6, 910.6 with code D50 (full-width partition wall) or with code D51 (full-width partition wall with 1 window) or with code D64 (partition with sliding door)

Model 910.6 with code D50 (full-width partition wall), model 910.6 with code D51 (full-width partition wall with 1 window)

AR68.74-D-0700TSF

Model 907.6 with code D50 (full-width partition wall), model 907.6 with code D51 (full-width partition wall with 1 window)

AR68.74-D-0700TSR

 Model 907.6/7, 910.6 with code D64 (partition with sliding door)
No reference document exists for these vehicles.

9

Remove respective protective strip (6).

AR88.80-D-1040TS

10

Remove respective sealing frame (7) in the repair area and position outside the working area.

11

Remove respective sealing frame (8) in repair area and position outside the working area.

12

Remove respective seat belt from B-pillar.

AR91.40-D-1015TS

13

Remove respective electrical wiring harness (17) in the repair area and position outside the working area.

14

Remove front roof lining.

AR68.30-D-7607TS

15

Remove center roof lining.

Model 907.6/7 with code V36 (Headliner)

AR68.30-D-7609TSR

16

Remove respective lock striker (9).

 Bolt, lock striker to B-pillar

*BA72.10-N-1007-01TS

17.1

Remove respective contact plate (10).

Model 907.6/7 except code EL9 (2-way front and rear speaker system) except code FY2 (Double lock) except code T50 (Electric closing assist for right sliding door) except code T55 (Electrical actuation for right sliding door), right side of vehicle, Model 907.6/7 except code EL9 (2-way front and rear speaker system) except code FY2 (Double lock) except code T51 (Electric closing assist for left sliding door) except code T56 (Electrical actuation for left sliding door), left side of vehicle, Model 910.6

 To do so, unscrew screws/bolts (13).

17.2

Remove respective cover from B-pillar.

Model 907.6/7 with code EL9 (2-way front and rear speaker system), Model 907.6/7 with code FY2 (Double lock), Model 907.6/7 with code T50 (Electric closing assist for right sliding door), right side of vehicle, Model 907.6/7 with code T55 (Electrical actuation for right sliding door), right side of vehicle, Model 907.6/7 with code T51 (Electric closing assist for left sliding door), left side of vehicle, Model 907.6/7 with code T56 (Electrical actuation for left sliding door), left side of vehicle

 To do this, unscrew screw/bolts.

18

Remove bottom guide bearing (11).

 To do so, remove screws/bolts (12).

 Striker pin to B-pillar

*BA72.16-N-1005-01TS

19

Remove respective underfloor paneling.

Model 907.6/7 with code XM1 (Noise abatement measures), model 910.6 with engine 651 with code XM1 (Noise abatement measures), model 910.6 with engine 780.703

AR61.30-D-1001TS

20

Remove respective underfloor paneling at HV battery module.

* Applies to Europe only

Model 910.6 with engine 780.703

AR61.30-D-1002TE

21

Install in the reverse order.

 Front door

Number

Designation

Model 907

Model 910

BA72.10-N-1007-01TS

Bolt, lock striker to B-pillar

Nm

20

20

 Sliding door

Number

Designation

Model 907.6/7/8, 910.6

BA72.16-N-1005-01TS

Striker pin to B-pillar

Nm

30