Remove/install exterior detachable parts and interior trim for replacing B-pillar

AR60.00-S-0014E

Remove/install exterior detachable parts and interior trim for replacing B-pillar

30.04.2020

Model

447, 448

Right side of vehicle

Model

447, 448

with code T19 (Sliding door left)

Left side of vehicle

Modification notes

18.12.2019

Method extended

Operation step 17.2

19.02.2020

Method extended

Operation steps 31.1, 31.2

30.04.2020

Method extended

Operation steps 33, 34

Shown on model 447.8, left side of the vehicle

Shown on MODEL 447.8 on right side of vehicle

1

Cable tie

5

Closing wedges

9

Cable

2

Subharness

6

Plug

10

Bolts

3

Front door sealing frame

7

Contact plates

11

Bracket

4

Seal

8

Plug

 Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.Typ 447 mit Motor 780

AS00.00-Z-0035-01A

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment

Typ 447 mit Motor 780

AH00.00-Z-0300-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Detach ground line of on-board electrical system battery.

AR54.10-S-0003E

2

Disconnect ground line of auxiliary battery.

Model 447.6/7 with code E28 (Additional battery for retrofit consumer) Model 447.8 with code EE8 (Battery 12V 100 Ah) Model 447.7/8 with code EE9 (Auxiliary battery 12 V/80 Ah)

AR54.10-S-0004E

3

Remove ground line of the auxiliary battery for ECO start/stop function.

Model 447 with code MJ8 (ECO start/stop function) except code D50 (Full-width partition wall) except code D51 (Full-width partition wall with 1 window) except code S23 (Two-seater front passenger seat), model 448

AR54.10-S-0111E

Model 447 with code D50 (Full-width partition wall) with code MJ8 (ECO start/stop function) Model 447 with code D51 (Full-width partition wall with 1 window) with code MJ8 (ECO start/stop function) Model 447 with code MJ8 (ECO start/stop function) with code S23 (Two-seater front passenger seat)

AR54.10-S-0111EE

4

Disconnect ground on additional battery for park pawl emergency shift.

Model 447 with engine 780 except code G42 (7G-TRONIC PLUS) except code G43 (9G-TRONIC), Model 447 with code G42 (7G-TRONIC PLUS) except code MJ8 (ECO start/stop function), model 447 with code G43 (9G-TRONIC) except code MJ8 (ECO start/stop function)

AR54.10-S-0120E

5

Remove sliding door from the damaged side of the vehicle.

AR72.16-S-1260E

If sliding door will be replaced,



Disassemble sliding door.

AR72.16-S-2210E

6

Remove front door on the damaged side of the vehicle.

AR72.10-S-0500E

If front door will be replaced,



Disassemble front door.

AR72.10-S-0510E

7

Remove mounting rail of the longitudinal member panel in the repair area from the damaged side of the vehicle.

Model 447.8, 448.8

AR88.80-S-6005CH

8

Remove bottom guide rail for the sliding door from the damaged side of the vehicle.

AR72.16-S-7816E

9

Remove door sill from the damaged side of the vehicle.

AR68.30-S-4100E

10

Remove front door sealing frame (3) in the repair area from the damaged side of the vehicle.

AR72.10-S-2120E

11

Remove cable ties (1) from the damaged side of the vehicle.

 Installation: Replace cable ties (1).

12

Place subharness (2) on the damaged side of the vehicle to one side.

13

Remove sliding door sealing frame in the repair area on the damaged side of the vehicle.

AR72.16-S-2120E

14

Remove trim from the B-pillar on the damaged side of the vehicle.

AR68.30-S-4700E

15

Remove seat belt from the B-pillar on the damaged side of the vehicle.

AR91.40-S-1015E

16

Remove seat belt height adjustment from the B-pillar on the damaged side of the vehicle.

AR91.40-S-1105E

17.1

Remove fuel filler flap.

If left side of vehicle is damaged.

Model 447 with engine 274, 622, 651, 654, 780.702
with code T19 (Sliding door left)
Left side of vehicleModel 448

AR88.60-S-6023E

17.2

Remove charging feed socket.

* only for Europe, in the event of damage to the left side of the vehicle.

Model 447 with engine 780.701
with code T19 (Sliding door left)Left side of vehicle

AR47.70-S-0006F

18

Remove lock striker from damaged side of the vehicle.

 Installation: Observe position of lock striker.

 Screw/bolt, lock striker to B-pillar

*BA72.10-N-1005-01G

If necessary,



Adjust lock striker.

Adjust front door

AR72.10-S-0550E

19

Remove sealing (4) from the damaged side of the vehicle.

20

Remove wedge-type stops (5) from the damaged side of the vehicle.

21

Remove grommets (6, 8) from the damaged side of the vehicle.

22

Remove screws (10) from the damaged side of the vehicle.

23

Remove bracket (11) from the damaged side of the vehicle.

24

Remove cable (9) from the damaged side of the vehicle.

25

Remove contact plates (7) from the damaged side of the vehicle.

26

Remove front seat from the damaged side of the vehicle.

AR91.10-S-1000E

27

Remove front passenger bench seat.

If right side of vehicle is damaged.

MODEL 447.6/7 with CODE S23 (Two-seater front passenger seat)

AR91.10-S-1035E

28

Remove crossmember for partition at B-pillar.

Model 447.6 with code D50 (Full-width partition wall) Model 447.6 with code D51 (Full-width partition wall with 1 window) Model 447.6 with code D62 (Preequipment for retrofitting partition wall)

AR68.74-S-0656E

29

Remove underfloor paneling from the damaged side of the vehicle.

Model 447 with engine 651 with code MX0 (BlueEFFICIENCY package), Model 447 with engine 654.9

AR61.30-S-1001E

30

Remove splash guard.

If left side of vehicle is damaged.

Model 447
with code H12 (Auxiliary hot-water heater)
with code T19 (Sliding door left)
except code MX0 (BlueEFFICIENCY package)
except code VQ1 (AVANTGARDE)
Left side of vehicleModel 447
with code HZ1 (Auxiliary heater (warm air))
with code T19 (Sliding door left)
except code MX0 (BlueEFFICIENCY package)
except code VQ1 (AVANTGARDE)
Left side of vehicleModel 447
with code MA6 (Emissions category Euro 6b N1 GR.III/N2)
with code T19 (Sliding door left)
except code MX0 (BlueEFFICIENCY package)
except code VQ1 (AVANTGARDE)
Left side of vehicleModel 447
with code MB6 (Low-emission vehicle, Euro 6 Gr. 1)
with code T19 (Sliding door left)
except code MX0 (BlueEFFICIENCY package)
except code VQ1 (AVANTGARDE)Left side of vehicle

AR61.30-S-0015E

31.1

Remove HV battery module.

Model 447 with engine 780.701
* Applies to Europe only

AR47.70-S-0001F

31.2

Remove high-voltage battery

Model 447 with engine 780.702
* Applies to Europe only

AR47.70-S-0002G

32

Remove coolant lines of rear heater at underbody in working area.

If left side of vehicle is damaged.

Model 447.7/8 with code H13 (Rear additional heat exchanger), model 447.7/8 with code HZ7 (Semiautomatically controlled air conditioning system, TEMPMATIC in rear), model 448

AR83.60-S-0013E

 Do not drain coolant, do not remove coolant hoses.

33

Remove refrigerant lines of rear air conditioning system at underbody on left in working area.

Model 447.7 with engine 622 with code HZ7 (Semiautomatically controlled air conditioning system, TEMPMATIC in rear), model 447.7/8 with engine 274, 651, 654 with code HZ7 (Semiautomatically controlled air conditioning system, TEMPMATIC in rear), model 448
If left side of vehicle is damaged.

 For this purpose, open respective brackets.
Do not extract refrigerant and do not disconnect refrigerant lines.

34

Remove refrigerant lines of rear air conditioning system at underbody on right in working area.

Model 447 with engine 780.702 with code HZ7 (Semi-automatically controlled air conditioning, TEMPMATIC in rear)
* only for Europe, in case of damage to right side of vehicle.

 For this purpose, open respective brackets.
Do not extract refrigerant and do not disconnect refrigerant lines.

35

Remove fuel tank.

If left side of vehicle is damaged.

Model 447 with engine 274 except code ZL3 (National version for Latin America), model 448 with engine 274

AR47.10-S-4100EG

Model 447 with engine 274 with code ZL3 (National version for Latin America), Model 447 with engine 622, 651, 654.9

AR47.10-S-4100E

36

Remove filler neck of fuel tank.

If left side of vehicle is damaged.

Model 447 with engine 274 except code ZL3 (National version for Latin America), model 448 with engine 274

AR47.10-S-7541EG

37

Remove AdBlue® container.

If left side of vehicle is damaged.

Model 447 with engine 622 Model 447 with engine 651 except for code MF4 (Low-emission vehicle Euro 4 Gr. III)

AR14.40-S-2014E

Model 447 with engine 654.9

AR49.20-S-2014EA

38

Install in the reverse order.

 Front door

Number

Designation

Model 447, 448

BA72.10-N-1005-01G

Screw/bolt, lock striker to B-pillar

Nm

20