D01.20-1028-06
1 Cover
2 Gasket
3 Radial sealing ring
4 Bolts
5 Hose
| Remove/install | ||
1 | Detach hose (5) for crankcase ventilation system on cover (1) | ||
2 | Remove bolts (4) | | |
3 | Remove cap (1) | Catch engine oil that flows out with an absorbent rag. | |
Installation: Clean sealing surfaces. Dowel pins on the cylinder head dictate the installation position of the cover (1). | |||
| Checking | ||
4 | Check seal (2) and radial sealing ring (3) for wear and damage | Replace cover (1) if necessary. | |
5 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
6 | Perform engine test run and check engine in the area of the cover (1) for leaks | ||
7 | Check engine oil level, correct if necessary | Do not check engine oil level until approx. 2 min after switching off the engine. | |
The engine oil level must not lie higher than the maximum marking, as this can result in damage to the engine. The fill level marks on the oil dipstick are designed for an engine oil temperature of approx. 80°C. Do not top up with any more oil for engine oil temperatures below this when filling the prescribed oil quantity. |
Crankcase ventilation, cylinder head cover
참조 문서
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험