Remove/install oil filter housing

AR18.20-D-3471WE

Remove/install oil filter housing

10.8.11

1.2.11

Remove oil dipstick guide tube, added

Step 5



Remove/install

Danger!

Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant.

Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not fill coolant into beverage holder.

Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

1

Remove engine trim panel

AR01.10-D-2405WE

2

Remove washer fluid reservoir of windshield washer system and place to one side with lines connected.

AR82.35-D-6000SD

3

Remove power steering pump and place aside with lines attached

AR46.30-D-0500WE

4.1

Remove refrigerant compressor and hang to side with lines attached

Vehicles with code (HH9) Regulated air conditioning, (Tempmatic)

AR83.55-D-5300US

4.2

Remove carrier with guide pulley

Vehicles without (HH9) Regulated air conditioning, (Tempmatic)

AR13.21-D-3350WE

5

Remove the oil dipstick guide tube

Model 900,

Model 906 with engine 651.955/956 as of 1.9.10

AR18.40-D-3510WD

6

Remove oil-water heat exchanger

AR18.30-D-6840WE

7

Unscrew cover (4) on oil filter element (1) and remove upward

 Collect dripping oil using a clean dry cloth.



*BA18.20-N-1001-01S

 Socket wrench bit

*103589020900

8

Unscrew bolts (2, 3)



*BA18.20-N-1002-01S

9

Remove oil filter housing (1) together with base plate (6)

 Installation: Clean sealing surfaces and install new sealing rings (5, 7).

10

Install in the reverse order

11

Check engine oil level, correct if necessary

 The engine oil level must not lie above the maximum marking. Engine damage may occur otherwise.



Low SPAsh multigrade service engine oils (specification 228.51)

Sheet 228.51

BB00.40-P-0228-51A



Multigrade service engine oil Low SPAsh

Sheet 229.31

BB00.40-P-0229-31A

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

12

Test run engine and check for leakage in area of oil filter housing (1) and base plate (6)

Number

Designation

Engine 651 in model 900

Engine 651 in model 906

BA18.20-N-1001-01S

Threaded cap on oil filter housing

Nm

25

25

BA18.20-N-1002-01S

Oil filter housing on crankcase

M6

Nm

10

10

M8

Nm

20

20