ar6350p140004ta

Install rear fender

Type ar · topic 63.50 · version 0109 · 2018-09-13

Applies to: Model 211.2

Where it sits

Function group 3 Body › 63 Side wall › 63.50 Rear fenders — Series 211 (models 2**)

EinPAS 35 Body/frame/detachable parts › 35.34 Sidewall › 35.34.35 Fender/sidewall — Series 211 (models 2**)

EinPAS 35 Body/frame/detachable parts › 35.37 Fender › 35.37.31 Rear fender — Series 211 (models 2**)

AR63.50-P-1400-04TA

Install rear fender

Model

211.2

The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.

Install rear fender

1

Install rear fender, taillamp, rubber seal and lock striker and fit.



2

Check gaps and adjust (arrows).



3

Fix rear fender in place.



4

Remove taillamp, rubber seal and locking eye.



5

Drill Ø 6.7 mm rivet holes on rear fender (area P).



6

Remove rear fender and deburr rivet holes on both sides.


P64.20-3167-06

Install rear fender

P63.50-2722-09

7

Apply sealant to foam parts on wheel well and C-pillar.

Install rear fender

P63.50-2733-09

8

Rear fender (areas D, E, F, H, K, L, N and Q).

9

Rear fender (areas I and J).

10

Heat wheel arch on rear fender and crimp carefully.

Heat area to be crimped.
Otherwise the corrosion protection layer can be damaged.

Bead analogously to undamaged side of vehicle
The crimp can also be made with an approved, standard commercial crimping tool.

Install rear fender

P63.50-2723-09

11

Rear fender (areas A, B and C).

Inert gas weld in intervals and allow to cool down in between. Reduces heat distortion.

12

Rivet rear fender with Ø 6.414 rivets (area P).

13

Weld in rear fender with (area R).

Install rear fender

14

Grind inert gas welds down flat.



15

Clean weld joints.



16

Fill surfaces on rear fender in cross-hatched areas with solder and smooth.



17

Remove grinding and drilling chips with wet/dry vacuum cleaner.


P63.50-2734-06