P46.30-2184-11
Shown on engine 113
1 Expansion reservoir of power steering pump
Modification notes
Fill | |||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | |
Danger! | Risk of injury to skin or eyes caused by hydraulic fluid spraying out under high pressure. Risk of poisoning caused by swallowing hydraulic fluid | Depressurize the hydraulic system completely before starting any work on the system. Wear protective clothing and safety glasses. | |
1 | Raise vehicle so that wheels are clear of the ground | ||
2 | Fill expansion reservoir (1) with MB steering gear oil | Do not start the engine! If the engine is started there is a risk of air entering the hydraulic steering system, which is then extremely difficult to remove. | |
Fill the expansion reservoir (1) of the power steering to approx. 10 mm below the upper edge of the reservoir with MB steering gear oil. | |||
Refill with MB-steering gear oil continuously until the oil level remains constant. | |||
| |||
With electrohydraulic P/S (EHPS). | |||
Bleeding | |||
3 | Turn steering wheel from steering stop to steering stop | Do not start the engine! If the engine is started there is a risk of air entering the hydraulic steering system, which is then extremely difficult to remove. | |
Turn steering wheel slowly from steering stop to steering stop until bubbles are no longer visible in the expansion reservoir (1). | |||
Repeat turning the steering from stop to stop several times (up to 30 times). During this process, MB steering gear oil must be poured into the expansion reservoir (1) by a second person. | |||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
4 | Start engine without moving the steering | Allow engine to run for approx. 1 min. at idle speed. | |
During this process, a second person must observe the oil level in the expansion reservoir (1) and add MB steering gear oil if necessary. | |||
5 | Turn steering wheel from steering stop to steering stop | When the engine is running turn the steering wheel slowly several times from steering stop to steering stop, meanwhile adding MB steering gear oil in expansion reservoir (1). | |
Repeat the procedure until the oil level in the expansion reservoir (1) remains constant and bubbles are no longer visible. | |||
| Check | ||
6 | Check oil level in the expansion reservoir (1) and fill up to the maximum fill level | The oil level in the expansion reservoir (1) must always be filled up to the maximum. | |
7 | Check steering system when engine is running for signs of leaks and proper function | In the event of leakage, find and eliminate cause. | |
8 | Lower vehicle |
Steering gear
Number | Designation | Model | Model | ||
BF46.20-P-1001-01D | Power steering | Filling capacity | Liters | 1,2 | 1,5 |
MB steering gear oil | Sheet | ||||
Repair materials
Number | Designation | Order number |
BR00.45-Z-1076-06A | Hydraulic fluid, Pentosin CHF 11S | A 001 989 24 03 |
Henviste dokumenter
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører
- as0000z001101a Fare for personskade pga. fastklemning eller knusning af fingre ved af-, påmontering og indstillingsarbejde på motorhjelm og bagklap, døre, dæksler og soltag.
- as0000z001301a Fare for kvæstelser på hud og øjne på grund af sprøjtende hydraulikvæske, som erunder højt tryk. Forgiftningsfare ved indtagelse af hydralikvæske