P20.20-2236-09
1 Engine hood catch
2 Radiator crossmember
15 Coolant line
16 Coolant line
4 Bolts
6 Bolts
P20.20-2222-09
8 Transmission oil line
9 Radiator
17 Coolant line
10 Bolts
14 Bolt
Modification notes
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off the lifting platform. | Align vehicle between columns of lifting platform and position four support plates at lifting platform support points specified by vehicle manufacturer. | |
Danger! | Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | |
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
1 | Disconnect battery ground line | Turn key in electronic ignition switch EIS into position "0". Key cannot be withdrawn. Vehicles with Keyless Go, code 889: Switch off engine, remove Keyless Go cards from the vehicle and store outside of transmitter range. Installation: After connecting, read out diagnostic trouble code memory, set time at instrument cluster, encode radio, normalize power windows and activate steering angle sensor. Vehicles with stationary heater: adjust time display on stationary heater. | |
| Notes on battery | All models | |
2 | Remove fan shroud | ||
3 | Drain coolant at radiator | ||
| Notes on coolant | All engines | |
4 | Drain coolant from low-temperature circuit | ||
5 | Remove fender liner front section in front fender | ||
6 | Remove both lamp units | ||
7 | Remove hood lock (1) from radiator crossmember (2) | ||
8 | Remove both clips from radiator crossmember (2) | ||
9 | Remove bolts (4) | ||
10 | Remove radiator crossmember (2) | ||
11 | Unscrew bolts (6) at both headlight mounts | ||
12 | Detach transmission oil line (8) at radiator (9) | Seal the connections. | |
Set of plugs | |||
| |||
13 | Remove screws (10) on bracket for circulation pump for low-temperature water circuit at the radiator (9) | ||
14 | Disconnect coolant lines from radiator for low-temperature water circuit | ||
15 | Unscrew bolt (14) for the AC line bracket at the radiator (9) | ||
16 | Disconnect coolant lines (15, 16, 17) from the radiator (9) | Installation: Fit new O-rings to the connection fittings. | |
Check coolant lines (15, 16, 17) for wear and damage, replace as necessary. | |||
17 | Disconnect power steering fluid lines from steering radiator | ||
18 | Unscrew condenser nuts from low-temperature radiator | ||
19 | Remove radiator unit by extracting upward | ||
20 | Install in the reverse order | ||
21 | Pour in coolant | ||
22 | Bleed cooling system | ||
23 | Bleed low temperature circuit | ||
24 | Inspecting cooling system for leaks | ||
25 | Check oil level in automatic transmission, correct if necessary | ||
26.1 | Check / adjust sensor setting of Distronic (DTR) | Vehicles with Distronic (DTR), code 219a. |
Radiator, coolant hoses
Number | Designation | Engine | ||
BA20.20-P-1001-01A | Union nut, automatic transmission oil line to radiator | Nm | 25 | |
Cooling system
Number | Designation | Engine | Engine | |||
BF20.00-P-1001-02Q | Cooling system | Total filling capacity | Main circuit | Liters | 12.5 | 12 |
Low temperature circuit | Liters | 2.1 | 2.1 | |||
Filling capacity of anticorrosion and | Main circuit | Liters | 6.25 | 6 | ||
Antifreeze down to -37°C | Low temperature circuit | Liters | 1 | 1 | ||
Specifications for Operating Fluids | Sheet | |||||
Sheet | ||||||
Set of stop plugs
129 589 00 91 00
Henviste dokumenter
- ah2000n208001a Oplysninger om kølervæske
- ah5410p000101a Oplysninger om batterier
- ah5410p000101a
- ar2000p1010ha
- ar2000p1010ha
- ar2000p114206ga
- ar2000p1142h
- ar2000p1142hm
- ar2000p1145h
- ar2040p6800im
- ar2700p0100ac Kontrol af oliestand i automatgearkasse og korrektion om nødvendigt
- ar3030p1000r
- ar5410p0003i Batteriets stelledning fra-, tilkobles
- ar8210p4730ma
- ar8210p4730ma
- ar8810p1300m Inderskærm i forskærm af-, påmonteres
- ar8840p3200m Af-, påmontering af motorhjelmslås
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører
- as0000z001001a Livsfare, hvis køretøjet glider ned fra eller tipper på liften.
- as2000z000101a Risiko for skoldningsskader på hud og øjne pga. sprøjtende, varm kølervæske. Risiko for forgiftning ved indtagelse af kølervæske
- as5410z000101a Brand-/eksplosionsfare på grund af kortslutning og udsivende knaldgas. Forbrændingsfare/fare for personskade ved ætsning af øjne, hud og sliminder på grund af batterielektrolyt/-tåge, kortslutning og lysbuepåvirkning. Fare for