W26.31-1019-09
1 | Range group | 9 | Output flange | 16 | Planetary gear set with shift mechanism | ||
5 | Shim | 10 | Carrier ring | 18 | Pilot bushing | ||
6 | Oil pump | 14 | Retaining ring | 26 | Drift | ||
8 | End cover | 15 | Sun gear |
21 | Main shaft |
69 | Oil restrictor |
W26.50-1214-06
70 | Oil pipe |
71 | Retaining ring |
W26.50-1215-06
| Install | ||
1 | Assemble range group (1) | ||
2 | Install pilot bushing (18) | ||
Internal extractor | |||
Counter stay | |||
3 | Install oil restrictor (69) into main shaft (21) | Only when an oil restrictor (69) is not already installed in the main shaft (21). | |
4 | Remove oil pipe (70) and retaining ring (71) from planet carrier | Only when an oil pipe (70) is installed in the planet carrier. | |
5 | Install sun gear (15) and retaining ring (14) | The chamfer on the internal toothing of the sun gear (15) must point towards the transmission, the flat side towards the circlip (14). | |
6 | Clean the sealing surfaces on the transmission housing center part and on the transmission housing rear part and coat with sealing compound | Loctite 5203 sealant | |
7 | Install drift (26) | Drift | |
8 | Fit range group (1) to transmission | By turning at the output flange (9) bring the toothing on the sun gear (15) and in the planetary gear set into mesh with the shifting device (16). | |
Holding fixture | |||
9 | Align the carrier ring (10) with the guide bolts on the transmission and move in the range group (1) | Holding fixture | |
10 | Screw in the bolts on the periphery of the transmission housing | Transmission housing rear section to transmission housing center section | |
11 | Determine shim (5) for oil pump (6) | ||
Play of oil pump | |||
12 | Install shim (5), oil pump (6) and valve element | ||
Note installed position of roll pin. | |||
13 | Install lock rod for interlock | ||
14 | Install oil lines | Only with code N55 (Transmission cooling). | |
Transmission oil cooling line to fitting | |||
15.1 | Install end cover (8) | Transmission without power takeoff | |
The shaft of the end cover (8) must engage in the oil pump (6). | |||
15.2 | Install power take-off | Transmission with power take-off | |
Power take-off 121 | |||
Power take-off 123, 124 | |||
Power take-off 125-10b | |||
Power take-off 125-11b/2c | |||
Power take-off 125-11b/1c | |||
Repair instructions have not been prepared for transmission 715.576. | |||
16 | Install propeller shaft at output flange (9) | Bolt/nut, propeller shaft to flange connectionBolt/nut, propeller shaft to flange connection | |
17 | Fill with transmission oil | ||
| Gear oils (Sheet 235.11) | ||
The transmission oil must reach the bottom edge of the oil filler opening. | |||
Filling screw to transmission housing |
000 589 33 33 00
Counter stay
715 589 09 15 00
Drift
000 589 26 33 00
Internal extractor
715 589 03 31 00
Holding fixture