Shown on transmission 715.500 |
1 | Oil pump end cover |
2 | O-ring |
3 | Drive shaft |
4 | Ball bearing |
5 | Retaining ring |
6 | Centering ring |
7 | Seal |
8 | Power take-off |
9 | Electrical connection (PTO indicator switch) |
10 | Compressed-air line |
11 | Electrical connection (PTO solenoid valve) |
W26.45-1221-06
| Notes on self-locking nuts and bolts | ||
| Notes on compressed air connection systems | ||
| Remove/install | ||
1 | Drain and collect transmission oil | ||
| Transmission 715.350/370/380/500/507/510/513/515/525/540/561 Transmission 715.520 without code G02 (Torque converter clutch (WSK)) Transmission 715.570 except in model 949 | ||
| Transmission 715.520 with code G02 (Torque converter clutch (WSK)) | ||
| Transmission 715.570 in model 949 | ||
2 | Remove drive flange from transmission |
| |
Transmission 715.570 | |||
Transmission 715.350 | |||
3 | Unpressurized circuit 4 of compressed-air system | ||
4.1 | Remove drive shaft from power take-off (8) | Power takeoff without hydraulic pump | |
Propeller shaft to power take-off | |||
4.2 | Remove hydraulic pump | Power takeoff with hydraulic pump | |
Do not disconnect the hydraulic lines if possible. | |||
5 | Detach air line (10) from power take-off (8) | ||
6 | Disconnect electrical connections (9, 11) | ||
7 | Remove power take-off (8) | Installation: Install new seal (7). | |
Screw/bolt, power take-off to transmission | |||
8 | Remove drive shaft (3) together with ball bearing (4) and centering ring (6) | ||
9 | Remove oil pump end cover (1) | Only when exchanging transmission or retrofitting a power take-off. | |
| Rear end cover modified | Transmission 715.5 as of 0224564 | |
Installation: Replace O-ring (2). | |||
10 | Install in the reverse order |