1 | Output flange (standard version) |
2 | Output flange (reinforced version) |
3 | O-ring (on series-version automatic transmission only) |
4 | Pressure plate (on series-version output flange only) |
5 | O-ring (on reinforced-version output flange only) |
6 | Pressure plate (on series-version output flange only) |
7 | O-ring (on reinforced-version output flange only) |
8 | Stretch bolt |
W26.30-1001-06
W26.40-0020-01
Shown on transmission with reinforced output flange | ||||
2 | Output flange | |||
8 | Stretch bolt | |||
9 | Retainer wrench | |||
Shown on transmission with reinforced output flange | ||||
2 | Output flange | |||
10 | Three-arm puller | |||
W26.40-0021-01
Danger ! | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
| Remove/install | ||
1 | Detach drive shaft from output flange (1 or 2) and place to one side | Bolt/nut, propeller shaft to flange connection | |
2.1 | Unscrew stretch bolt (8) and remove thrust washer (4) with O-ring (3). | For output flange (1), series version | |
Installation: Replace O-ring (3). | |||
Stretch bolt to output flange, transmission 715.370/380/515/525 | |||
Stretch bolt to output flange, transmission 715.500/507/510/513/517/520/527/540/561/567/568 | |||
Retainer wrench | |||
2.2 | Unscrew stretch bolt (8). | With output flange (2), reinforced version | |
Stretch bolt to output flange, transmission 715.370/380/515/525 | |||
Stretch bolt to output flange, transmission 715.500/507/510/513/517/520/527/540/561/567/568 | |||
Retainer wrench | |||
3 | Pull off output flange (1 or 2) using three-arm puller (10) | Use thrust piece (Ø20 mm, length min. 100 mm). | |
Installation: Heat up output flange (1 or 2) to approx. 80 °C. | |||
4 | Remove thrust washer (6) from output flange (2) | Only with output flange (2), reinforced version. | |
Installation: Replace O-rings (5 and 7). | |||
5 | Install in the reverse order |
717 589 00 31 00
Retainer wrench