W26.45-1218-09
Shown on transmission 715.500 |
1 | Power take-off 123 | 4 | Drive shaft | 7 | Compressed-air line | ||
2 | Power take-off 124 | 5 | O-ring | 8 | Electrical connection (PTO indicator switch) | ||
3 | Seal | 6 | Oil pump end cover | 9 | Electrical connection (PTO solenoid valve) |
| Notes on self-locking nuts and bolts | ||
| Notes on compressed air connection systems | ||
| Remove/install | ||
1 | Drain and collect transmission oil | ||
| Transmission 715.350/370/380/500/507/510/513/515/525/540/561 Transmission 715.520 without code G02 (Torque converter clutch (WSK)) Transmission 715.570 except in model 949 | ||
| Transmission 715.520 with code G02 (Torque converter clutch (WSK)) | ||
| Transmission 715.570 in model 949 | ||
2 | Remove drive flange from transmission |
| |
Transmission 715.570 | |||
Transmission 715.350 | |||
3 | Unpressurized circuit 4 of compressed-air system | ||
4.1 | Detach drive shaft from power take-off 123 (1) or power take-off 124 (2) | Vehicles without hydraulic pump | |
Propeller shaft to power take-off | |||
4.2 | Remove hydraulic pump | Vehicles with hydraulic pump | |
Do not separate hydraulic lines if possible, collect hydraulic fluid if necessary. | |||
5 | Detach compressed air line (7) at solenoid valve | ||
6 | Disconnect electrical connections (8, 9) | ||
7 | Remove power take-off 123 (1) or power take-off 124 (2) | Installation: Install new seal (3). | |
8 | Remove drive shaft (4) | ||
9 | Remove oil pump end cover (6) | Only when exchanging transmission or retrofitting a power take-off. | |
| Rear end cover modified | Transmission 715.5 as of 0224564 | |
Installation: Replace O-ring (5). | |||
10 | Install in the reverse order |