Engine | 470.9, 471.9, 473.9 in model 963.0/4 |
with code B3H (Water-type secondary retarder) | |
with code F1R (L-cab) | |
except code N7G (EnginePTO, front, pre-inst.for AW22.5 Frigo gen.) | |
except code N7H (EnginePTO, front, pre-inst. for AW30 Frigo gen.) | |
Engine | 470.9, 471.9, 473.9 in model 964.000/001/002/003/014/016/02/041/200/201/202/203/214/216/22/24/31/32/34/401/402/403/414/416/42 |
with code B3H (Water-type secondary retarder) | |
with code F1R (L-cab) |
Install |
Overview of fastening points. The fastening points (A) are located two rows of holes behind the attachment points of the steering gear oil container.
Shown on vehicle with a steel sprung front axle |
W20.00-1114-06
1 | Attach the holder (2) to the attachment points (A) and put on the screw/bolts loosely. |
Use screw/bolts M16x40. |
2 | Bend the holder (1) to the side somewhat. |
3 | Remove screw/bolts (3) at the rear attachment points (arrows B). |
Shown on vehicle with an air-sprung front axle |
W20.00-1115-06
4 | Attach the holder (4) with spacer sleeves (5) according to the attachment points (A) and put on the screw/bolts loosely. |
Use screw/bolts M16x90. |
Shown on vehicle with an air-sprung front axle |
W20.00-1116-06
5 | Attach the coolant filter (6) to the lower attachment points (C) and put on the screw/bolts loosely. |
The coolant filter (6) is screwed onto the holder (4). The holder (2) is screwed from the rear to the holder (4). |
6 | Tighten holder (2) and holder (4) on frame. |
7 | Tighten three screw/bolts on coolant filter (6). |
The fourth screw/bolt (7) is tightened later for installation of the coolant line. Use screw/bolts M8x110. |
8 | Mount connection fitting (8) onto coolant filter (6) . |
W20.00-1117-06