Remove/install exterior detachable parts and interior trim for replacing outside part of B-pillar

AR60.00-D-0013TSC

Remove/install exterior detachable parts and interior trim for replacing outside part of B-pillar

01.04.2019

Model

907.2

Shown on model 907.2, left side of vehicle

1

B-pillar outer section

Shown on model 907.2, left side of vehicle

1

B-pillar outer section

2

Seat belt

3

Bellows

4

Fuel filler flap

5

Filler neck

6

Front door sill trim

7

Entrance paneling

8

Protective strip

9

Frame seal

10

Frame seal

11

Lock striker

12

Door holder

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Remove respective hinge of front door.

AR72.10-D-2662TS

2

Remove respective hinge of rear door.

AR72.12-D-2661TSR

3

Remove respective seat belt (2).

AR91.40-D-1015TS

4

Remove respective electrical wiring harness in repair area of B-pillar outer section (1) and position outside the working area.

5

Remove respective boot (3).

 Guide electric lines through opening in B-pillar outer section (1) and position in vehicle interior outside the working area.

 The number of electrical connectors may vary depending on the equipment.

6

Remove respective door holder (12).

AR72.12-D-2100TSR

7

Remove fuel filler flap (4).

If left side of vehicle is damaged.

AR88.60-D-6023TS

8

Remove filler neck (5).

If left side of vehicle is damaged.

AR47.10-D-7541TS

9

Remove front roof lining.

AR68.30-D-7607TS

10

Remove roof lining in rear.

AR68.30-D-7619TSR

11

Remove respective front door sill trim (6).

AR68.30-D-1306TS

12

Remove respective door sill trim (7).

AR68.30-D-1307TSR

13

Remove respective protective strip (8).

AR88.80-D-1040TS

14

Remove respective sealing frame (9) in repair area and position outside the working area.

15

Remove respective sealing frame (10) in repair area and position outside the working area.

16

Remove respective lock striker (11).

 To do this, unscrew screw/bolts.

 Bolt, lock striker to B-pillar

*BA72.10-N-1007-01TS

17

Remove respective underfloor paneling.

If installed.

AR61.30-D-1001TS

18

Install in the reverse order.

 Front door

Number

Designation

Model 907

BA72.10-N-1007-01TS

Bolt, lock striker to B-pillar

Nm

20