P27.00-2144-09
1d | Seal | 17 | Oil pump | 17o | O-ring | ||
1w | Torque converter housing | 17a | Bolt (7 pcs.) | 17r | Impeller | ||
16 | Multi-disk brake | 17g | Housing | 17z | Impeller | ||
16a | Screw (11 each) |
P27.00-2149-07
1d | Seal | 1w | Torque converter housing | 16 | Multi-disk brake |
| Remove | ||
Notes on automatic transmission | |||
1 | Remove drive unit | ||
The drive unit consists of the drive shaft, multidisk clutch K2, front planet carrier, internal plate carrier, multidisk clutch K1 and multidisk brakeB3. | |||
2 | Remove bolts (17a) and remove oil pump (17) | Mark installation position of oil pump (17). | |
Screw two opposing bolts (17a) into housing (17g) and detach oil pump (17) using a suitable tool. | |||
3 | Unscrew bolts (16a) and remove multidisk brake (16) | Loosen the multidisk brake (16) by applying gentle blows using a plastic mallet. | |
If necessary: | |||
| |||
Disassemble/assemble multi-disk brake (16). | |||
4 | Remove seal (1d) | ||
| Install | ||
5 | Place gasket (1d) on torque converter housing (1w) and align | The seal (1d) can normally be reused several times. The seal (1d) must not exhibit any scratches and must not be coated with sealant. | |
6 | Mount multidisk brake (16) onto torque converter housing (1w) | The installation position is predetermined by a dowel pin on the multidisk brake (16). | |
Bolt, multi-disk brake B1 to converter housing | |||
7 | Attach oil pump (17) | Replace radial sealing ring and O-ring (17o). | |
Insert the impeller (17r) in such a way that the chamfer (arrow) points toward the housing (17g). | |||
Bolt, oil pump with multi-disk brake B1 to torque converter housing | |||
8 | Install drive unit |
参照文書
- ah2719p000101nkb オートマチック·トランスミッションに関する注意事項
- ah2719p000101nkb
- ar2750d0612we
- ar2750d0870we