The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
P63.50-4132-09
1 | Expose spot welds on rear fender (1) and cut out (areas A). |
2 | Separate adhesive bead between outer rear wheel well and rear fender (1) (area B). |
The rear fender is bonded to the outer rear wheel well (1). |
3 | Expose spot welds on rear fender (1) and cut out (areas C). |
It is necessary to cut out shared spot welds on rear fender (1) and rear center section through two sheet metal thicknesses. |
P63.50-4133-06
4 | Expose spot welds on rear fender (1) and cut out (areas D). |
It is necessary to cut out shared spot welds on rear fender (1) and side wall through two sheet metal thicknesses. |
P63.50-4134-06
P63.50-4135-09
5 | Heat rear fender (1) in crosshatched areas. |
Cross-hatched areas are bonded with adhesive. |
6 | Remove rear fender (1). |
P63.50-4136-09
7 | Remove remaining adhesive material in area of outer rear wheel well (area E1). |
The height of the remaining adhesive should be max. 2 mm. Always remove loose adhesive. |
8 | Repair bare points with primer stick (area E1). |
9 | Sand down mating surfaces to bare metal in cross-hatched areas . |
Sand down spot weld flanges to bare metal on both sides. |
10 | Remove grinding dust and drill chips. |
11 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas E). |
Observe pretreatment of bonding surfaces. |