AR20.20-P-3865MC | Remove/install radiator | 15.2.12 |
ENGINE 275.950 in MODEL 220.176
ENGINE 137.970 in MODEL 215.378, 220.178 /878
P20.20-2159-09
Shown on model 220.176
1 Engine hood catch
2 Radiator crossmember
6 Bolt
11 Bracket
15 Coolant line
16 Coolant line
3 Clamp
4 Bolt
5 Bracket
P20.20-2160-06
Shown on model 220.176
7 Bracket
12 Plastic cover
18 Bolt
P20.20-2161-09
Shown on model 220.176
8 Transmission oil line
14 Bolt
17 Coolant line
9 Radiator
10 Bolt
13 Bolt
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | |
Danger! | Risk of injury to skin and eyes due to scalding caused by contact with hot coolant spray Risk of poisoning caused by swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | |
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
Danger! | Risk of accident due to vehicle starting off when engine is running Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
1 | Turn key in electronic ignition switch EIS to position "0". | Key cannot be withdrawn. | |
With Keyless Go, code 889: Press Start-Stop button once more until ignition is off, remove Keyless Go cards from vehicle and place out of the transmitter range. | |||
2 | Disconnect ground line from battery | ||
| Notes on battery | ||
3 | Remove fan shroud | ||
4 | Drain coolant at radiator | Engine 137 | |
Engine 275 | |||
| Notes on coolant | ||
5 | Remove front parts of the fender liner in the front fender | ||
6 | Remove both lamp units | Model 215 | |
Model 220 without Xenon headlamp unit | |||
Model 220 with Code 612b Xenon headlamp unit | |||
7 | Detach left and right front engine hood catch (1) from radiator crossmember (2) | Model 215 | |
Model 220 | |||
8 | Remove both clamps (3) from radiator crossmember (2) | ||
9 | Remove bolts (4) | ||
10 | Detach right bracket (5) of radiator crossmember (2) | ||
11 | Remove radiator crossmember (2) | ||
12 | Unscrew bolts (6) at both headlight mounts | ||
13.1 | Remove bracket (7) for ABC distributor | Vehicles with Active Body Control (Code 487) only. | |
14 | Dismount transmission oil line (8) at radiator (9) | Seal the connections. | |
Set of plugs | |||
| |||
15.1 | Unscrew bolts (10) for low temperature water circuit circulation pump bracket at radiator (9) | Engine 275 | |
16 | Remove bracket (11) | ||
17 | Remove left and right plastic cover (12) | ||
18.1 | Unscrew bolts (13) for low temperature water circuit cooler at radiator (9) | Engine 275 | |
19 | Unscrew bolt (14) for A/C line bracket at radiator (9) | ||
20 | Disconnect coolant lines (15, 16, 17) at the radiator (9) | Installation: fit new O-rings to the connection fittings. | |
Inspect coolant lines (15, 16, 17) for damage, replace if necessary. | |||
21 | Unscrew bolts (18) at radiator (9) | ||
22 | Install in the reverse order | ||
23 | Pour in coolant | Engine 137 | |
Engine 275 | |||
24 | Bleed cooling system | ||
25 | Inspecting cooling system for leaks | ||
26 | Check oil level in automatic transmission, correct if necessary | ||
27.1 | Check / adjust the sensor setting of Distronic (DTR) | Vehicles with Distronic (DTR) Code 219a |
Radiator, coolant hoses
Number | Designation | Engine | ||
BA20.20-P-1001-01A | Union nut, automatic transmission oil line to radiator | Nm | 25 | |
Set of stop plugs
129 589 00 91 00
Henviste dokumenter
- ah2000n208001a Oplysninger om kølervæske
- ah5410p000101a Oplysninger om batterier
- ah5410p000101a
- ar2000p1010ha
- ar2000p1010ha
- ar2000p114206ga
- ar2000p1142h
- ar2000p1142ha
- ar2000p1142ha
- ar2040p6800ac
- ar2700p0100ac Kontrol af oliestand i automatgearkasse og korrektion om nødvendigt
- ar3030p1000r
- ar5410p0003i Batteriets stelledning fra-, tilkobles
- ar8210p4730m Lygteenhed af-, påmonteres
- ar8210p4730ma
- ar8210p4730ma
- ar8210p4730n
- ar8210p4730n Af-, påmontering af lygteenhed
- ar8810p1300m Inderskærm i forskærm af-, påmonteres
- ar8840p3200m Af-, påmontering af motorhjelmslås
- ar8840p3200n
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører
- as0000z001001a Livsfare, hvis køretøjet glider ned fra eller tipper på liften.
- as2000z000101a Risiko for skoldningsskader på hud og øjne pga. sprøjtende, varm kølervæske. Risiko for forgiftning ved indtagelse af kølervæske
- as5410z000101a Brand-/eksplosionsfare på grund af kortslutning og udsivende knaldgas. Forbrændingsfare/fare for personskade ved ætsning af øjne, hud og sliminder på grund af batterielektrolyt/-tåge, kortslutning og lysbuepåvirkning. Fare for