AR07.16-P-1110A | Removing, installing low temperature cooler | 9.8.97 |
ENGINE 611.960 in MODEL 202.133 /134 /193 /194
P47.00-0276-06
1 Bottom part of noise encapsulation
2 Coolant hose
3 Coolant hose
4 Retaining clip
5 Front end crossmember
6 Low temperature cooler
7 Cover panel
8 Retaining bar
9 Air duct
| Removing, installing | ||
1 | Remove bottom part of noise encapsulation (1) | ||
Danger! | Risk of injury to skin and eyes from scalding from hot coolant which splashes out. Risk of poisoning from swallowing coolant. | Do not open the cooling system unless the coolant temperature is below 90 °C. Open cap slowly and allow the pressure to release. Do not pour coolant into containers for drinks. Wear protective gloves, protective clothes, and eye protection. | |
2 | Drain coolant, pour in | At radiator | |
3 | Disconnect coolant hoses (2, 3) | Inspect condition of coolant hoses, replace if necessary. Collect coolant which flows out. | |
4 | Remove cover panel (7) | Remove retaining clips. | |
5 | Pull off clips (4) at front end crossmember (5) | ||
6 | Remove front end crossmember (5) | ||
7 | Detach hood cable | Place to the side in the engine compartment. | |
8 | Unbolt air duct (9) at low temperature cooler (6) | ||
9 | Remove low temperature cooler (6) | Installation: attach retaining bar (8) to air duct. | |
| |||
10 | Install in the reverse order | ||
11 | Inspect cooling system for leaks |
Common-Rail Diesel Injection CDI, fuel cooling system
Henviste dokumenter
- ar2000p1010ha
- ar2000p1010ha
- ar2000p1142hb
- ar2000p1142hb
- ar8840p3100e Af-, påmontering af træk til motorhjelm
- ar9430p5300a Af-, påmontering af støjindkapslingsunderdele
- as2000z000101a Risiko for skoldningsskader på hud og øjne pga. sprøjtende, varm kølervæske. Risiko for forgiftning ved indtagelse af kølervæske