S27.19-4528-09
1 | Transmission housing | 4e | Transmission plug | 82 | Detent plate | ||
2 | Oil guide pipe | 4s | Bolt | N15/11 | Fully integrated transmission control (VGS) electric controller unit | ||
3 | Oil pan | 4w | Selector valve | ||||
4d | Sealing ring | 34 | Oil filter |
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Notes on self-locking nuts and bolts | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Notes on automatic transmission | ||
| Remove/install | ||
1 | Switch off ignition | ||
2 | Remove heat shield above the transmission connector (4e) | ||
3 | Remove oil pan (3) | ||
| |||
Do not use lint-free cleaning cloth for cleaning. Chamois leathers are the most suitable. | |||
4 | Remove oil filter (34) | Installation: Replace oil filter (34). | |
5 | Detach 5-pin plug coupling from transmission connector (4e) | ||
Clean transmission connector (4e) and 5-pin plug connection. | |||
6 | Remove fully integrated transmission control (VGS) electric controller unit (N15/11) | | |
To do so, remove bolts (4s). | |||
Installation: Replace bolts (4s) and oil guide pipe (2). Insert oil guide pipe (2) before installation of fully integrated transmission control (VGS) electric controller unit (N15/11) into transmission housing (1). | |||
Screw/bolt, electrohydraulic controller unit to transmission housing | |||
When inserting the fully integrated transmission control (VGS) electric controller unit (N15/11) | |||
| |||
Insert selector valve (4w) into driver of detent plate (82) | |||
Insert selector valve into driver of detent plate | |||
7 | Install in the reverse order | ||
| Check | ||
8 | Check transmission oil level; correct if necessary | ||
9 | Read out fault memory with diagnostic system | ||
| |||
Clear existing errors. | |||
10 | Perform transmission adaptation using diagnostic system | ||
Danger ! | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
11 | Test run engine and check transmission for leaktightness and proper operation | Shift through the gears of the transmission a few times before putting into service in order to flush any air pockets out of the fully integrated transmission control (VGS) electric controller unit (N15/11). |