T18.00-0016-01
1 Threaded cap
2 Oil drain screw
3 Oil pan
4 Oil filler neck
5 Dipstick
T18.00-0017-01
| Remove | ||
Danger! | Risk of injury to skin and eyes caused by handling hot or glowing objects. | Wear safety gloves, protective clothing and safety glasses, if necessary. | |
1 | Warm up engine to normal operating temperature | Perform oil change only when engine at normal operating temperature. | |
2 | Open engine compartment flap at rear | ||
3 | Slacken threaded cap (1) and pull out slightly together with filter element | This allows the engine oil to run back into the oil pan (3). | |
4 | Remove threaded cap (1) together with filter element | ||
5 | Remove filter element from threaded cap (1) | ||
6 | Detach lower engine compartment paneling | Only if the engine oil is drained via the oil drain screw (2). | |
| Remove/install bottom engine compartment paneling | ||
Lowering | |||
7.1 | Drain engine oil | Remove the oil drain screw (2) from the oil pan (3). Collect the engine oil using a suitable container. | |
7.2 | Suction off engine oil | ||
8 | Screw oil drain screw (2) into oil pan (3) | Only if the engine oil has been drained via the oil drain screw (2). | |
| |||
Filling | |||
9 | Pour in engine oil at oil filler neck (4) | | |
| Install | ||
10 | Install a new filter element in threaded cap (1) | Ensure the filter element is correctly positioned. | |
11 | Fit threaded cap (1) together with filter element | Apply a thin coating of oil to the O-ring on the threaded cap (1); fit a new O-ring if damaged. | |
| |||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
12 | Build up oil pressure in engine | Do not start engine until oil pressure has built up otherwise there is a risk of engine damage. | |
To do so, crank the engine by pressing the Start pushbutton switch (S1/10) and Stop pushbutton switch (S1/11) until the oil pressure indicator lamp goes out. Pressing both buttons at the same time prevents the engine from starting. | |||
| General information on function of Start/Stop button | ||
| Check | ||
13 | Inspect oil level at dipstick (5) | Only inspect the engine when it is at operating temperature and switched off. | |
| Check oil level | ||
14 | Check threaded cap (1) and oil drain screw (2) for leaks | ||
15 | Install lower engine compartment paneling. | Only if the engine oil has been drained via the oil drain screw (2). | |
| Remove/install bottom engine compartment paneling | ||
16 | Close engine compartment flap at rear |
Oil pan
Number | Designation | Engine 457.9 | ||
BA01.45-N-1001-01J | Oil drain screw to oil pan | M201.5 | Nm | 60 |
M221.5 | Nm | 70 | ||
M261.5 | Nm | 80 | ||
Oil filter
Number | Designation | Engine 457.9 except 457.944 | ||
BA18.20-N-1008-01J | Oil filter housing screw cap | Nm | 25 | |
Engine lubrication