| A = Delivery inspection (worksheet for conducting a delivery inspection in accordance with DIN 14502 Sheet 2 Para. 5.1.; for fire-fighting vehicles as per DIN 14502 Sheet 1) |
G00.20-3142-11
Customer | Order number |
License plate number | Current mileage |
Date | Signature |
A | Input condition not OK: | | |||||
Completed | |||||||
| |||||||
| | ||||||
General | |||||||
| Check that the vehicle identification number and weight specifications match the details in the registration documents and on the vehicle identification plate. |
| | ||||
| Determine wheel and axle loads. |
| |||||
Compare actual values against manufacturer's specifications (vehicle identification plate). | |||||||
| Check oil levels and leak tightness of engine, transmission, axles, transfer case, power take-offs and steering. |
| | ||||
| Check all lubrication points for accessibility. |
| | ||||
| Check engine cooling system corrosion/antifreeze protection. |
| | ||||
____________ °C | |||||||
Electrical system | |||||||
| Check deactivation of transport mode. |
| |||||
Model 963, 964 of model generation 5 | |||||||
| Batteries: Clean battery clamps and battery terminals (if required) and check/correct fluid level |
| | ||||
| Battery: Check charge level. |
| | ||||
Use Midtronics battery test device. | |||||||
| Check all lines and hoses, sensor cables for chafe marks and correct routing. |
| | ||||
If damage or a leak is present, | |||||||
| |||||||
determine cause and correct. | |||||||
After obtaining special order. | |||||||
| Signaling system, indicator lamps: Check function. |
| | ||||
| Windshield wipers, windshield washer system, headlamp cleaning system: Check for function and adjustment. |
| | ||||
| Exterior lighting: Check function. |
| | ||||
While doing so, check position lamp circuit, these must light up constantly for high and low beam (also applies for extra position lamps). | |||||||
| Headlights: Check adjustment, adjust |
| | ||||
Including front fog lamps, if installed. | |||||||
Wheels, tires | |||||||
| Tires: Check condition. |
| | ||||
| Tire pressure: Check/correct. |
| | ||||
| Wheel nuts and spare wheel mounting: Check for tight seating. |
| | ||||
Steering | |||||||
| Mechanical steering components: Check condition. |
| | ||||
| Steering gear: Check for tight seating. |
| | ||||
Observe official torque specifications! | |||||||
Brake system | |||||||
| Compressed-air system: Check for leak tightness. |
| | ||||
When the engine is switched off and the parking brake is engaged, the pressure drop over 10 minutes may not exceed 0.1 bar. | |||||||
| Compressed-air drier: Check for proper function. |
| | ||||
Check installation date of granulate cartridge. | |||||||
| Brake testing on test stand |
| |||||
Enter result in the table "Brake values". | |||||||
Clutch, transmission | |||||||
| Remote clutch control: Check for proper function. |
| | ||||
Model 963, 964, 967.6 with code G5F (Clutch, remote controlled) | |||||||
| On vehicles with automatic transmission, check external accelerator shutoff and selector lever lock. |
| | ||||
Test drive | |||||||
| Check vehicle for operational readiness and road safety. |
| | ||||
The test drive should last for approx. 10 to 20 km. | |||||||
| Check brakes using plotting measuring instrument when performing the test drive. |
| |||||
Only if a test stand is not available, check brakes using plotting measuring instrument during perform a test drive. | |||||||
Final inspection (after test drive) | |||||||
| Check engine, transmission, transfer case, axles, steering, power-steering pump, and cab tilt system for leak tightness and condition. |
| | ||||
If a leak is present, | |||||||
| |||||||
determine cause and correct. | |||||||
After obtaining special order. | |||||||
| Exhaust system: Check leak tightness and condition. |
| | ||||
If damage or a leak is present, | |||||||
| |||||||
determine cause and correct. | |||||||
After obtaining special order. | |||||||
| Retighten spring U-bolts on front axle. |
| |||||
Model 967.6, 976 | |||||||
Observe official torque specifications! | |||||||
Vehicle documentation | |||||||
| Check documentation of modifications in VeDoc; add if necessary. |
| | ||||
The modification must be documented in the AO text category. | |||||||
| Fill out certification for customer. |
| |||||
Delivery inspection for fire-fighting vehicles, form | |||||||
Brake values in kN |
1st front axle | 2nd front axle | 1st rear axle | 2nd rear axle | 3rd rear axle | ||||||
Left | Right | Left | Right | Left | Right | Left | Right | Left | Right | |
Service brakes | ||||||||||
Parking brake | ||||||||||
Complaints were made about the following: |
Comments: |
Cost settlement: |
Certificate issued: |