Shown on model 447.8, left side of the vehicle |
S60.00-4575-06
1 | Cable tie |
2 | Front door sealing frame |
3 | Subharness |
4 | Floor covering |
S60.00-4574-04
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.Model 447 with engine 780 | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment | Model 447 with engine 780 | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Detach ground line of on-board electrical system battery. | ||
2 | Disconnect ground line of auxiliary battery. |
| |
3 | Remove ground line of the auxiliary battery for ECO start/stop function. |
| |
Model 447 | |||
4 | Disconnect ground on additional battery for park pawl emergency shift. |
| |
5 | Remove front door on the damaged side of the vehicle. | ||
If front door will be replaced, | |||
| |||
Disassemble front door. | |||
6 | Remove fender liner in the front fender from the damaged side of the vehicle. | ||
7 | Remove front bumper. | ||
8 | Remove mounting rail of the longitudinal member panel in the repair area from the damaged side of the vehicle. |
| |
9 | Remove front fender from the damaged side of the vehicle. | ||
10 | Remove door sill from the damaged side of the vehicle. | ||
11 | Remove front door sealing frame (2) in the repair area from the damaged side of the vehicle. | ||
12.1 | Remove fuel filler flap. | If left side of vehicle is damaged. | |
Model 447 with engine 274, 622, 651, 654, 780.702 | |||
12.2 | Remove charger feed socket. | * only for Europe, in the event of damage to the left side of the vehicle. | |
Model 447 with engine 780.701 | |||
13 | Place floor covering (4) in the repair area to one side. | ||
14 | Remove cable ties (1) from the damaged side of the vehicle. | Installation: Replace cable ties (1). | |
15 | Place subharness (3) on the damaged side of the vehicle to one side. | ||
16 | Remove underfloor paneling from the damaged side of the vehicle. |
| |
17 | Remove splash guard. | If left side of vehicle is damaged. | |
Model 447 | |||
18.1 | Remove HV battery module. | Model 447 with engine 780.701 | |
18.2 | Remove high-voltage battery | Model 447 with engine 780.702 | |
19 | Remove coolant lines of rear heater at underbody in working area. | If left side of vehicle is damaged. | |
Model 447.7/8 | |||
Do not drain coolant, do not remove coolant hoses. | |||
20 | Remove refrigerant lines of rear air conditioning system at underbody on left in working area. | Model 447.7 with engine 622 | |
For this purpose, open respective brackets. | |||
21 | Remove refrigerant lines of rear air conditioning system at underbody on right in working area. | Model 447 with engine 780.702 | |
For this purpose, open respective brackets. | |||
22 | Install in the reverse order. |
Powiązane dokumenty
- ah0000z030001a Ogólne wskazówki dotyczące pojazdów z instalacją wysokiego napięcia i/lub akumulatorem litowo-jonowym i/lub gazowym systemem napędu oraz osobistego wyposażenia ochronnego
- ah6800n000101s Wskazówki dotyczące wykonywania prac naprawczych we wnętrzu pojazdu
- ar4770s0001f
- ar4770s0002g
- ar4770s0006f
- ar5410s0003e
- ar5410s0003e
- ar5410s0004e
- ar5410s0111e
- ar5410s0111ee
- ar5410s0120e
- ar6130s0015e
- ar6130s1001e
- ar6830s4100e
- ar7210s0500e
- ar7210s0510e
- ar7210s2120e
- ar8360s0013e
- ar8810s1000e
- ar8810s1300e
- ar8820s2000e
- ar8860s6023e
- ar8880s6005ch
- ar8880s6005ch
- as0000z001001a Zagrożenie życia na skutek ześlizgnięcia lub spadnięcia pojazdu z podnośnika.
- as0000z003501a Zagrożenie życia podczas prac przy elementach i systemach U >=30 V napięcie zmienne (AC) bądź U >=60 V napięcie zmienne