D15.12-1115-06
1 Electrical connectors
2 Bolts
3 Power steering pump expansion reservoir
4 Bolts
B6/4 Left intake camshaft sensor
B6/5 Right intake camshaft sensor
B6/6 Left exhaust camshaft sensor
B6/7 Right exhaust camshaft sensor
| Remove/install | ||
1 | Loosen bolts (4) on power steering pump expansion reservoir (3) | When removing the left exhaust camshaft sensor (B6/6). | |
| |||
2 | Swivel power steering pump expansion reservoir (3) far enough to the side until the left exhaust camshaft sensor (B6/6) is accessible | When removing left exhaust camshaft sensor (B6/6). | |
3 | Disconnect electrical connector (1) at left exhaust camshaft sensor (B6/5, B6/6, B6/4, B6/7) | ||
4 | Remove bolt (2) and pull camshaft sensor (B6/4, B6/5, B6/6, B6/7) out of front cover on cylinder head | Installation: Replace sealing ring. | |
| |||
5 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
6 | Perform test run engine and check engine in the area of the camshaft sensors (B6/4, B6/5, B6/6, B6/7) for leaks |
Position sensor
Number | Designation | Engine | ||
BA15.10-N-1002-03C | Bolt, camshaft sensor to front cover on cylinder head | Nm | 8 | |
Power steering pump
참조 문서
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험