bt3320p000201a

Supporting joint with integrated rebound stop

Type bt · topic 33.20 · version 0100 · 2000-09-25

Applies to: MODEL 202

Where it sits

Function group 2 Chassis › 33 Front axle › 33.20 Wheel location, wheel hubs — Series 202

EinPAS 17 Drivetrain/axle › 17.50 Front axle › 17.50.42 Steering knuckle/wheel hub/wheel bearing — Series 202

MODEL 202

BT33.20-P-0002-01A

Supporting joint with integrated rebound stop

Model 202

Production breakpoint data/Revisions/New features

World manufac-
turing code

Model

LHS
RHS

Product.
plant

Vehicle ident. end no. as of

Vehicle ident. end no. up to

Production period as of

Production period up to

Type of and reason for revision

Reference/comments

202

01.09.95

Standardization with model 210

Supporting joint with integrated rebound stop

P33.20-0304-01

Supporting joint with integrated rebound stop, model 202 standardized with model 210.

The following modifications result:

- (as of 05/95) the welded-on stop pin is not used any more on the upper wishbone and the sheet metal thickness has been reduced from 3 mm to 2 mm.

- The stop bracket on the body is replaced by a simple cable bracket (since 06/95).

Supporting joint with integrated rebound stop

P33.20-0305-01

Function

A taper in the supporting joint housing (arrow) and an associated recess in the ball pin (7c) limit the rebound angle.

Only the revised upper wishbone and the revised supporting joint are supplied.

When replacing an upper wishbone on vehicles before the use of supporting joints with integrated rebound stop, the supporting joint must also be replaced.