The following steps are shown on the left side of the vehicle and must be performed analogously on the right side in the event of damage.
1 | Mark separating point on rear fender (1) and cut (area A). |
Transfer separation point from vehicle. |
P63.50-4109-05
P63.50-4116-09
2 | Cut out spot welds on lock striker bracket (area B). |
Only if C-pillar is not replaced. |
3 | Drill out spot weld on lock striker bracket with Ø 6.5 mm bit (area C). |
Only if C-pillar is not replaced. |
4 | Remove lock striker bracket. |
Only if C-pillar is not replaced. |
5 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
6 | Remove grinding dust and drill chips. |
7 | Coat insides of spot weld flanges with zinc dust paint. |
P63.50-4117-09
8 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
9 | Remove grinding dust. |
10 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas D). |