P46.10-2422-05
Shown on vehicle with code (I49) multifunction steering wheel (FFO)
1 Steering wheel
2 Nut
3 Electrical connector for horn
4 Electrical connector for multifunction steering wheel (with code (I49) multifunction steering wheel (FFO))
5 Electrical wiring
| Remove/Install | ||
1 | Remove airbag unit from steering wheel | ||
2 | Move steering wheel (1) to horizontal position | Front wheels in straight-ahead position. | |
3 | Disconnect electrical connector for signaling horn (3) | ||
4 | Unscrew nut (2) of steering wheel (1) | | |
Get assistance in counterholding the steering wheel (1). | |||
Replace self-locking nuts (2). | |||
5 | Carefully pull the steering wheel (1) off the steering column and guide the electrical lines (5) outwards through the opening in the steering wheel (1) | ||
6.1 | Disconnect multifunction steering wheel electrical connector (4) | Only on vehicles with code (I49) multifunction steering wheel (FFO). | |
7 | Remove steering wheel (1) | Do not twist the clock spring contact when the steering wheel (1) is removed. | |
Installation: Ensure that the front wheels are in the straightahead position before installing the steering wheel (1). The three guide lugs of the inner vinyl ring of the steering column switch must align accurately with the three notches in the steering wheel (1). When installed only rotate the steering wheel (1) when the tightened fastening nut is tightened in order not to damage the clock spring contact and toothing. | |||
8 | Install in the reverse order | ||
9.1 | Carry out function check of multifunction steering wheel | Only on vehicles with code (I49) multifunction steering wheel (FFO). | |
10 | Conduct a road test | Tests during the road test: | |
Turn signal canceling: If the three guide lugs of the steering column switch do not accurately align with the three notches in the steering wheel (1) faultless turn signal indicator reset is no longer guaranteed. | |||
Electronic Stability Program (Electronic Stability Program) (ESP): If the three lugs of the steering column switch do not accurately align with the three notches in the steering wheel (1), the faultless function of the ESP is no longer guaranteed. | |||
Airbag indicator lamp: The SRS indicator lamp must not light up on full steering lock in both directions. | |||
Steering wheel (1) position: If the steering wheel (1) is not on straight, offset it by a maximum of one tooth, if the difference is greater adjust the front axle toe-in. See | |||
Perform chassis alignment check |
Steering shaft
Referenced documents
- ar4020p0200ff Perform chassis alignment
- ar9160p0660ff Remove/install airbag unit on steering wheel