AR40.20-P-0331FB | Checking rear axle camber | 30.3.98 |
MODEL 210
with CODE (979) Special protection version
with CODE (Z04) Light armoring
with CODE (Z06) B6 armoring
ST + = positive camber
ST - = negative camber
P40.20-0234-03
| Inspecting | ||
1.1 | Check vehicle level at front and rear axle and adjust, if necessary | With Mercedes-Benz measuring device. | |
1.2 | Check vehicle level at front and rear axle with electronic inclination measuring instrument and adjust, if necessary | With electronic inclination measuring instrument. | |
2 | Check camber at rear axle | The camber cannot be adjusted at the rear axle. Large deviations at the rear wheel camber may be caused by the following: Difference in vehicle level too great between the left and right side of the vehicle. Bent camber strut. Frame floor damaged due to an accident. Difference in level at the mounting points for the rear axle carrier between the left and right side of the body. Experience shows that bending caused by an accident also has an effect on the toe. |
Test values for rear axle camber
Number | Designation | Model 210.0/2 | ||
BE40.20-P-1001-09B | Camber at vehicle level | +40 mm | °3.0 | -0° 42' (30') |
+30 mm | °2.0 | -0° 52' (30') | ||
+20 mm | °2.0 | -1° 04' (30') | ||
+10 mm | °0 | -1° 17' (30') | ||
0 mm | °1.1 | -1° 30' (30') | ||
-10 mm | °2.1 | -1° 44' (30') | ||
-20 mm | °3.1 | -1° 59' (30') | ||
-30 mm | °4.1 | -2° 16' (30') | ||
-40 mm | °5.1 | -2° 34' (30') | ||
-50 mm | °6.1 | -2° 52' (30') | ||
Referenced documents
- ar4020p0300fb Checking vehicle level at front and rear axles
- ar4020p0301fb Check vehicle level at front and rear axle with electronic inclinometer, adjust if necessary