W01.45-0004-06
1 Oil filling line
2 Gasket
3 Oil pan
4 Bolt
5 Sealing ring
6 Oil drain screw
7 Soundproofing panel
Modification notes
8.8.00 | Value changed from 60 Nm to 65 Nm | Value modified in BA01.45-N-1002-01B for engine 904.9, 906.9 | |
8.8.00 | Value changed from 80 Nm to 85 Nm | Value modified in BA01.45-N-1002-01B for engine 904.9, 906.9 |
| Remove/install | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
1 | Tilt cab | ||
| Notes on tilting the cab | ||
2 | Remove soundproofing (7) at oil pan (3) | Installation: Quick-release fittings must latch. | |
3 | Extract or drain engine oil | ||
| |||
| |||
Engine oil suction unit | |||
4 | Detach oil filler line (1) at oil pan (3) | ||
5 | Unscrew bolts (4) and take off oil pan (3) | As of engine end no. 004313 up to engine end no. 004449 a shortened bolt (4) was installed in the left rear (on compressor side) of the oil pan (3). | |
Installation: Clean sealing surfaces and install a new seal (2). | |||
| |||
6 | Remove oil level sensor | Only when installing a new oil pan (1). | |
| |||
7 | Install in the reverse order | ||
8 | Check engine oil level using oil dipstick or on display, correct if necessary | Observe engine oil grade set in maintenance system or Specifications for Operating Fluids. | |
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
9 | Start engine and observe oil pressure gauge with the engine idling | Crank engine with the starter for not more than 90 seconds. Wait for about 2 minutes before repeating starting attempt. Do not increase engine revolutions until oil pressure is displayed. The oil pressure gauge must indicate oil pressure after about 10 seconds. | |
10 | Switch off engine and check for leaks |
Check values for engine oil pressure
Number | Designation | Engines | ||
BE18.00-N-1001-01C | Engine oil pressure at | Idling speed | bar | 0.5 |
maximum speed | bar | 2.5 | ||
Oil pan
Number | Designation | Engines | ||
BA01.45-N-1001-01B | Bolt, oil pan to crankcase | Nm | 25 | |
BA01.45-N-1002-01B | Oil drain screw on oil pan | M201.5 | Nm | 65 |
M261.5 | Nm | 85 | ||
Oil level sensor, oil pressure sensor
Number | Designation | Engines | |
BA18.40-N-1002-01C | Oil level sensor to oil pan | Nm | 50 |
Engine lubrication
Referenced documents
- ah6080n000301a Notes on tilting the cab
- ar1800w303502a Suction off engine oil or drain and fill up again
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.
- as6080z000101a Risk of injury caused by body parts being pinched or crushed as cab is tilted