Remove/install oil pan

AR01.45-T-7500A

Remove/install oil pan

10.11.11

 

Remove/install

1

Remove engine compartment encapsulation below the oil pan (1)

2

Open engine compartment flap and additional flap at the rear

3

Drain oil

 See Operator's Manual

3.1

Extract oil

 The guide tube (3) for minimum oil level inspection is used as oil extraction pipe.

Observe the operating instructions provided by the manufacturer of the engine oil extractor.

Engine oil suction unit

gotis://S_18.1_0

4

Remove screw/bolt (2) on guide tube (3) for oil dipstick to oil pan (1)

 Pull oil dipstick (7) out of guide tube (3) somewhat.
Oil dipstick (7) for oil level indicator minimal.

5

Remove screw/bolt (4) on guide tube (5) for oil dipstick (8) to oil pan (1)

 Pull dipstick slightly out of the guide tube (3).
Oil dipstick (8) for oil level indicator maximal.

6

Loosen hose clamp on oil separator (6) and detach hose

7

Remove screw/bolts (9) for oil filler pipe (10) using oil separator (6) at oil pan (1)

8

Remove guide (3, 5) and oil filler pipe (10) with oil separator (6)

9

Unscrew nuts (11) for oil return line (12) at oil pan (1) and remove oil return line (12)

10

Remove screw/bolts at oil pan (1) and remove oil pan


 Installation: Install new gasket.

*BA01.45-N-1001-01G

Clean sealing surface on housing and oil pan (1) free of grease and additionally coat seal at the corners with sealant.

*BR00.45-Z-1012-01A

11

Install in the reverse order

12

Pour in engine oil at oil filler neck (10)



*BF18.00-N-1001-01D

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near a running engine

Secure vehicles to prevent it from moving by itself.

Wear closed and close-fitting work clothes.

Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

13

Crank engine by actuating the starter

 When actuating the starter press the Engine Stop button simultaneously to prevent the engine starting.

Observe oil pressure gauge! It must indicate pressure after a few seconds.

Operate starter for a maximum of 20 seconds. Then wait for a minute.

 Pull up accelerator pedal if the reservoir pressure is missing.

14

Start engine

 Warm up engine.

15

Check for leaks with engine running

16

Turn off engine

Check oil level after about 5 minutes; correct if necessary.

Number

Designation

Engine 447

Engine 489

BA01.45-N-1001-01G

screw/bolt, oil pan to cylinder crankcase

Nm

30

30

Number

Designation

Engines 447, 489

BF18.00-N-1001-01D

Engine oil

Filling capacity with oil filter

Liters

20.5 to 24.5

Filling capacity with oil filter and heat exchanger

Liters

-

Automatic engine oil replenishment reservoir

Liters

16

Specifications for Operating Fluids

Sheet

BB00.40-P-0228-01A

Sheet

BB00.40-P-0228-03A

Sheet

BB00.40-P-0228-05A

Number

Designation

Order number

BR00.45-Z-1012-01A

Sealant, Omnifit FD 3041

A 002 989 47 20 10