P62.20-2723-07
Shown on model 461.332 |
9 | Power steering oil line | 12 | Line package | 15 | Screw | ||
10 | Angle hose | 13 | Wheel well paneling | 16 | Washer fluid reservoir | ||
11 | Cable grommet |
Shown on model 461.332 |
8 | Bracket |
A6 | STH or HB heater unit |
A7/3 | Traction system hydraulic unit |
X62/26 | Left front ABS rpm sensor connector |
X88/14 | Left front brake pad contact sensor connector |
P62.20-2722-06
Shown on model 461.332 |
2 | Power steering system cooling line |
4 | Lower radiator crossmember |
5 | Upper radiator crossmember |
14 | Screw |
E1/1 | Left stealth headlamp |
E2/1 | Right stealth headlamp |
P62.20-2724-05
| Remove/install | ||
Topical note | Notes on self-locking nuts and bolts | ||
1 | Remove left front fender |
| |
2 | Remove mud guards | Model 461.331 with engine 612.966 | |
The mud guards are fastened to the wheel well paneling (13). | |||
3 | Disconnect electrical connector from left front fog lamp (E5/1) and right front fog lamp (E5/1) | Only for vehicles with front fog lamps | |
4 | Disconnect electrical line from left stealth headlamp (E1/1) and right stealth headlamp (E2/1) | Model 461 with engine 612.966 | |
5 | Remove power steering system cooling line (2) |
| |
6 | Remove angle hose (10) | ||
7 | Remove radiator crossmember with cable from engine hood lock | ||
8.1 | Removing additional fan | Vehicles with code (H02) Air conditioning | |
Model 461.302/332/342/345 with engine 612.966 | |||
Model 461.331 with engine 612.966 | |||
8.2 | Remove charge air cooler | Model 461 with engine 642 | |
9 | Pull left low temperature cooler out of bracket | Model 461.302/331/332/342/345 with engine 612.966 | |
10 | Remove left front headlamp unit | ||
Headlamp range control must be removed. | |||
11 | Take off front bumper |
| |
Model 461.305/333/340/343 with engine 642 | |||
Only loosen rear bolts and pull bumper in direction of travel. | |||
12 | Remove lower radiator crossmember (4) | Separate cable tie. | |
Bolt, radiator crossmember to front end | |||
13 | Remove upper radiator crossmember (5) | Model 461.302/331/332/342/345 with engine 612.966 | |
Do not remove cable from engine hood lock. | |||
14 | Remove STH or HB heater unit (A6) |
| |
Model 461.304/334/344/346 with engine 642.975 | |||
15 | Remove power steering pump high-pressure hose to steering gear from wheel well paneling (13) | Model 461.305/333/340/343/392 with engine 642 | |
16 | Remove traction system hydraulic unit (A7/3) |
| |
17 | Remove washer fluid reservoir (16) of windshield washer system |
| |
18 | Unscrew bracket (8) from coolant line. | Model 461 with engine 612.966 | |
19 | Disconnect left front brake pad contact sensor connector (X88/14) | ||
20 | Unclip left front ABS rpm sensor connector (X62/26) from bracket and disconnect | ||
21 | Open cable tie of wiring harness below brake unit | ||
22 | Open cable tie of wiring harness below washer fluid reservoir (16) | ||
23 | Pull power steering fluid line (9) through opening in wheel well paneling (13) | ||
24 | Remove bolt (14) from wheel well paneling (13) on frame | Bolt, body to frame | |
25 | Remove screws (15) | ||
26 | Remove wheel well paneling (13) | Lift wheel well paneling (13) at front and pull out connection fitting of power steering oil line on steering gear (9). | |
27 | Route line package (12) through cable passage (11) | | |
If headlamp range adjustment is defective: | |||
| |||
Replace headlamp range control. | |||
| |||
28 | Install in the reverse order |
Odkazované dokumenty
- ah0000n000101a Upozornění k samopojistným šroubům a maticím
- ar0941p6817gy Demontáž, montáž chladiče plnicího vzduchu
- ar4230p0705gr Demontáž, montáž hydraulické jednotky ABS
- ar4625p3010gs Demontáž, montáž chladicího vedení posilovače řízení
- ar6230p2300a
- ar8210p4000gl
- ar8210p4730g Demontáž, montáž osvětlovacího tělesa
- ar8235p6000gl
- ar8330p5600glc
- ar8330p5600gs
- ar8370p5302gl
- ar8370p5302glc
- ar8370p5302gx
- ar8810p1000gl
- ar8820p2000gl
- ar8820p2000sw