1 | Housing cover |
2 | Sealing ring |
3 | Filter element |
4 | Container (for dirt deposits) |
5 | Housing |
N07.57-0225-01
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
| Remove | ||
1.1 | Tilt cab. | Model 405 | |
| |||
1.2 | Open hood. | Model 437.4 | |
| Model 437.42/43 | ||
Model 437.465 | |||
2 | Open cap on fuel tank and close again. | In order to reduce the overpressure in the fuel system. | |
3 | Remove housing cover (1) of fuel filter. | Remove housing cover (1) only after the fuel has drained out of the housing (5). | |
4 | Remove housing cover (1) with filter element (3) and unclip by pressing at side. | ||
5 | Pull container (4) out of housing (5) at shackles. | Ensure that any deposited dirt does not enter the housing (5). | |
6 | Clean housing cover (1) and container (4). | ||
| Install | ||
7 | Replace sealing ring (2). | Grease sealing ring (2) slightly. | |
8 | Insert new filter element (3) into housing cover (1). | ||
9 | Insert container (4) into housing (5). | Ensure correct installation position. | |
10 | Screw on housing cover (1) with filter element (3) and tighten it. | Cover on fuel filter housing | |
11 | Start engine and bleed fuel system. | Allow engine to run for approx. 1 min. The fuel system is bled automatically. | |
12 | Check leak tightness between housing cover (1) and housing (5) with engine running. | Visual inspection only. | |
13 | Switch off engine. | ||
14.1 | Tilt back cab. | Model 405 | |
| |||
14.2 | Close hood. | Model 437.4 | |
| Model 437.42/43 | ||
Model 437.465 |