Shown on model 461 |
1 | Cap |
2 | Coolant expansion reservoir |
P20.30-2277-01
Shown on model 463 |
1 | Cap |
2 | Coolant expansion reservoir |
P20.30-2278-01
| Check | ||
Warning | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
Topical note | Notes on coolant | ||
1 | Switch off ignition | ||
2 | Open hood | ||
3 | Unscrew cap (1) for coolant expansion reservoir (2) | Slowly screw open end cover (1) and release pressure, then unscrew end cover (1). | |
4 | Using an antifreeze tester, check that coolant contains sufficient anticorrosion agent and antifreeze | Use approved anti-corrosion and antifreeze agents only. | |
Coolant mixing ratio | |||
If the mixing ratio is incorrect, correct the coolant composition: | |||
| |||
After obtaining special order. | |||
5 | Check coolant level | ||
Notes on coolant level | |||
If coolant level is too low: | |||
| |||
Subject to a separate repair order, check the engine cooling system for leaktightness. | |||
6 | Close coolant expansion reservoir (2) with cap (1) | ||
7 | Close engine hood |