Fuel injectors (Y62y1 to Y62y6) | ||
1 | Fault code ( Readout on generic scan tool) | P201D Cylinder 1 (Y62y1) (P0201) P2021 Cylinder 2 (Y62y2) (P0202) P201F Cylinder 3 (Y62y3) (P0203) P201E Cylinder 4 (Y62y4) (P0204) P2022 Cylinder 5 (Y62y5) (P0205) P2020 Cylinder 6 (Y62y6) (P0206) |
2 | Fault storage Actuation of the engine diagnosis indicator lamp (EURO3/4) or CHECK ENGINE (MIL) malfunction indicator lamp | after expiry of test duration and fault following two successive driving cycles with faults |
3 | Checking frequency | Continuous |
4 | Checked signal or status | Current/voltage test on respective fuel injector |
5 | Fault setting conditions Limit values Short circuit to ground Short circuit to +12V Open circuit in wiring Checking duration |
Voltage lower than 2,5 volts Current higher than 4,2 amps No voltage on fuel injection valve Approx. 4 to 8 V on under no load output of the ME control unit approx. 1 seconds |
6 | Check prerequisites | Battery voltage between 8 and 17 V |
7 | | The actuation of each fuel injector is tested for line interruption and short circuit (to ground or battery voltage). A short circuit to ground and a line discontinuity will be recognized when the output stages are locked, while a short circuit to the battery voltage is recognized when the output stages are conducting. The output stage is immediately no longer activated when a fault arises. |
8 | | In the event of a short circuit to ground, the corresponding fuel injector is continuously open. |