AR01.00-P-2410V | Disconnecting and connecting engine wiring harness | 15.5.97 |
ENGINE 112.942 in MODEL 163.154
ENGINE 112.970 in MODEL 163.157
ENGINE 113.942 in MODEL 163.172
ENGINE 113.981 in MODEL 163.174
ENGINE 113.965 in MODEL 163.175
P15.18-2014-06
Shown on Model 163.154
1 Cover of fuse module
2 Cover of relay module
3 Bracket
4 Positive lead
5 Electrical line
W10 Battery ground
W16/6 Electronics ground of right major assemblies compartment
P01.00-0433-01
P01.00-0435-01
P15.18-2013-01
Shown on Model 163.154
W11/5 Ground strap of engine/body
Shown on Model 163.154
X22 Connector of engine compartment and engine
Shown on Model 163.154
N3/10 Motor electronics control module
| Remove/Install | ||
1 | Disconnect ground of battery (W10) | Installation: After connecting, read out fault memory, encode radio and normalize power windows. Vehicles with stationary heater: adjust time display on stationary heater. | |
2 | Remove cover of fuse module (1) | ||
3 | Remove cover of relay module (2) | ||
4 | Remove electronics ground of right major assemblies compartment (W16/6) of engine wiring harness | ||
5 | Remove electrical line (5) at positive lead (4) | ||
6 | Disconnect positive cable (4) at battery | ||
7 | Take off bracket (3) of positive cable (4) | Bracket next to coolant circulation pump. | |
8 | Separate connector of engine compartment and engine (X22) in fuse and relay module | ||
9 | Separate connectors of motor electronics control module (n3/10) | Release locking arm, separate plug connection | |
10 | Unscrew ground strap of engine/body (W11/5) to vehicle frame | ||
11 | Install in the reverse order | ||
12 | Read out and erase diagnostic trouble code memory with HHT or STAR DIAGNOSIS | After completion of the work, it is necessary to process and erase the DTCs stored in the DTC memory during assembly and testing work due to disconnected lines and simulation. Diagnosis Manual Volume 2 Index 0: Connecting and using test equipment |