1 | Engine hood |
2 | Fender |
3 | Bumper |
4 | A-pillar water deflector |
5 | Radiator grille |
6 | Headlamps |
7 | Antenna |
8 | Side turn signal |
9 | Cover |
S62.20-0032-06
10 | Crossmember |
11 | Wheel arch |
12 | Headlamp support |
13 | Front end crossmember |
S62.20-0031-06
| Remove/install | ||
Danger | The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases | Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system. | |
Topical note | Guidelines for replacing front end/wheel well | ||
Topical note | Measures for preventing damage to vehicles or components when performing electric welding work | ||
Topical note | General information on body repair | ||
Mounting points on the body | |||
Mounting points on complete vehicle | |||
1 | Remove engine hood (1) | ||
2 | Remove front bumper (3) | ||
3 | Remove front grille (5) | ||
4 | Remove antenna (7) |
| |
For automatic antenna (code E68) | |||
if fitted | |||
5 | Remove trim from outer A-pillar | ||
| |||
6 | Remove headlamp (6) | ||
7 | Unscrew cover (9) | ||
8 | Remove front fender (2) | ||
9 | Cover all detachable body components that remain in the area to be repaired | ||
10 | Set up of Celette straightening bracket set |
| |
11 | Remove lock crossmember (13) | ||
12 | Remove crossmember (10) | ||
13 | Remove support | ||
14 | Replace headlamp mount (12) | ||
15 | Partially rebuild longitudinal member | ||
16 | Partially rebuild wheel arch panel (11) | ||
17 | Partially rebuild axle/engine subframe | ||
| Measure | ||
18 | Gap dimensions on hoods, doors and lids |
| |
19 | Install in the reverse order |
Powiązane dokumenty
- ah0000n000501a Zabezpieczenia zapobiegające uszkodzeniom pojazdu lub jego elementów podczas spawania elektrycznego
- ah6000n000101a Ogólne wskazówki dotyczące napraw nadwozia
- ah6010n130001a Punkty mocowania na nadwoziu
- ah6010n135001a Punkty mocowania na kompletnym pojeździe
- ah6200n000201a Wytyczne dot. wymiany przedniej części pojazdu lub nadkola
- ar3135s1100a
- ar6000s070001v
- ar6010s1070a
- ar6220s1260a
- ar6220s1280a
- ar6220s1300a
- ar6230s1360a
- ar6230s2100a
- ar8210s4720a
- ar8262s8101a
- ar8262s8105a
- ar8800s2115a
- ar8800s2302a
- ar8810s1000a
- ar8820s2000a
- ar8840s3000a
- ar8880s8500a
- as0000z000701a Zagrożenie dla życia przez wysokie napięcie przy spawaniu elektrycznym. Niebezpieczeństwo wybuchu podczas spawania w pobliżu materiałów łatwopalnych. Niebezpieczeństwo urazu na skutek odprysków przy spawaniu oraz promieniowania u