Remover/install bar-type link

AR35.15-P-0200MCC

Remover/install bar-type link

11.4.12



Remove

1

Raise vehicle using drive-on lifting platform

2

Unscrew nuts (5).

 The bolts (4) remain in the left bar link (3) and right bar link (6).

3

Remove screws/bolts (1)

4

Remove rear axle crossmember (2) together with left bar link (3) and right bar link (6)

5

Remove bolts (4)

6

Drill out rivets (7) and rivet (arrow A) and remove heat shield (8)

Not on model 451.39/49

 Twist drill bit set

*450589017000

Rechargeable drill / screwdriver

gotis://G_58.0_01.1

7

Remove remainder of rivets

Not on model 451.39/49

8

Remove corresponding bolt (9) and remove left bar link (3) or right bar link (6)



Install

The installation may only take place with an unladen vehicle (approx 75 kg weight on the driver seat and a full tank or approx 20 kg weight in the front passenger area).

9

Align left bar link (3) or right bar link (6) corresponding to the adjustment dimension of bar link to rear axle crossmember (a) and tighten with bolt (9)

*BE35.15-P-1001-01B



*BA35.15-P-1002-02C

10

Position heat shield (8) on rear axle crossmember (2) and press in rivets (7) and rivet (arrow A) using electromechanical blind riveter

Not on model 451.39/49

Electromechanical blind riveter

gotis://K_68-80_06.0

11

Insert bolts (4)

12

Position rear axle crossmember (2) together with left bar link (3) and right bar link (6) on vehicle and tighten bolts (1)



*BA35.10-P-1003-01F

13

Rock vehicle several times to settle suspension

 Ensure that the vehicle is not relieved of load by a lifting platform, axle jack, wheels-free jack, transmission jack, support blocks or similar.

14

Secure left bar link (3) and right bar link (6) using bolts (4) and nuts (5)



*BA35.15-P-1001-02C

15

Perform wheel alignment check

 Depending on the workshop equipment select between the measurement variant with recording the vehicle level or without recording the vehicle level.

without recording the vehicle level

AR40.20-P-0200MCC

with recording the vehicle level

AR40.20-P-0200MCE

Number

Designation

Type 451

BE35.15-P-1001-01B

Adjustment dimension, bar link to rear axle crossmember

mm

130

Number

Designation

Model
451.3/4

BA35.10-P-1003-01F

Screw/bolt, crossmember to integral carrier

Nm

65

Number

Designation

Model 451.3/4

BA35.15-P-1001-02C

Bolt, bar-type link to axle tube

Nm

90

BA35.15-P-1002-02C

Bolt, bar-type link to crossmember

Nm

65