ar0520p6010va

Check basic position of camshafts

유형 ar · 주제 05.20 · 버전 0102 · 2008-02-26

적용 대상: ENGINE 272 in MODEL 171 Grundstellung der Nockenwellen bei eingebauten vorderen Deckeln am Zylinderkopf bei 55° Kurbelwinkel vor OT'

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 1 엔진 › 05 엔진제어장치 › 05.20 캠샤프트, 캠샤프트 조절장치 — 시리즈 171

EinPAS 15 엔진 › 15.17 엔진 컨트롤 › 15.17.30 밸브 드라이브 — 시리즈 171

엔진/변속기에도 적용: 272 ***

AR05.20-P-6010VA

Check basic position of camshafts

16.2.04

ENGINE 272 in MODEL 171
Grundstellung der Nockenwellen bei eingebauten vorderen Deckeln am Zylinderkopf bei 55° Kurbelwinkel vor OT

Check basic position of camshafts

P05.20-2163-06

1 Marking on belt pulley

2 Guide edge on timing case cover

3 Markings on pulse wheels

Remove/Install

1

Open engine hood

AR88.40-P-1000V

2

Remove air filter housing

AR09.10-P-1150VA

3

Remove Hall sensor on camshafts

AR15.10-P-2000VA

Check

4

Turn the engine at the crankshaft in the direction of rotation of the engine (arrow) to 55° crankshaft angle before ignition TDC (305° on the belt pulley) and check the basic position of the camshafts

The 305° marking (1) on the belt pulley must be aligned with the guide edge (2) on the timing case and the markings (3) of the pulse wheels must be positioned in the center of the sensor bore holes. If necessary, set the basic position of the camshafts when removing/installing the camshaft adjuster:

Remove/install camshaft adjusters

AR05.20-P-7201VA

5

Install in the reverse order

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near engine

Secure vehicle to prevent it from moving.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

6

Carry out an engine test run and check the engine for leaks

참조 문서