AP55.20-D-5550A | Dumper system - check function, play and attachment | 23.8.11 |
MODEL 901, 902, 903, 904, 905 with CODE (P56) Three-way dumper body (Meiller)
MODEL 668, 670
with CODE (PJ1) Dumping platform, 3100x2200x350
with CODE (PJ2) Dumping platform, 4000x2200x350
N55.20-2027-05
1 Dumping platform switch
2 Auxiliary frame
3 Safety rope
4 Safety strut
The following work instructions apply to Meiller dumper systems installed in the Mercedes-Benz plant. In the case of other dumper systems, the operating and maintenance procedures of the relevant manufacturer must be observed. These alternative procedures may deviate from those described below. | |||
Danger! | Risk of death. There is a risk of death to persons located within the dumping area or underneath the raised dumping platform during operation. Risk of injury There is a risk of body parts being crushed or pinched when the dumping platform is lowered. | All persons must remain outside the dumping area of the dumping platform during its operation. Always secure the dumping platform with platform supports before starting any work underneath it. | |
| Checking | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
1 | Start engine, switch on power take-off | In models 668, 670, the "Power take-off" indicator lamp must light up. | |
2 | Operate the dumping platform switch (1) and raise the dumping platform | Remaining underneath an unsupported dumping platform is life-threatening and is therefore prohibited. The "dumping platform" indicator lamp must light up before the dumping platform is raised. | |
3 | Check the operation and setting of the shutoff valve; to do this, the dumping platform will have to be raised as far as the cutoff. | When the platform is raised backwards or to the side, the shutoff valve must open before the safety ropes (3) tighten; this also applies at increased engine speed and maximum pump delivery rate. | |
If damage or defects are found: rectify any damage/defects - subject to separate repair order. | |||
4 | Check condition and attachment of frame (2) and safety ropes (3). | If damage or defects are found: rectify any damage/defects - subject to separate repair order. | |
5 | Check whether dumping platform safety strut (4) is still serviceable | If damage or defects are found: rectify any damage/defects - subject to separate repair order. | |
6 | Lower dumping platform and switch off power take-off | The power take-off indicator lamp must go out. | |
7 | Turn off engine |
참조 문서
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험
- as5520z000101a 틸팅 모드에서 틸팅 영역 또는 들어 올려진 덤핑 바디 아래에 위치하여 발생할 수 있는 사망 위험 덤핑 바디를 내릴 때 신체의 일부가 끼이거나 짓 눌려서 입을 수 있는 상해 위험