ap2000i2080b

Replace coolant

유형 ap · 주제 20.00 · 버전 0115 · 2011-12-22

적용 대상: ENGINES 904.941 in MODEL 684.482

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 1 엔진 › 20 엔진냉각 › 20.00 서문 — 시리즈 684 (모델 482) · 시리즈 904 (모델 941)

EinPAS 15 엔진 › 15.25 엔진 냉각 시스템 › 15.25.5 냉각수 회로 전체 — 시리즈 684 (모델 482) · 시리즈 904 (모델 941)

AP20.00-I-2080B

Replace coolant

13.12.11

ENGINES 904.941 in MODEL 684.482

Replace coolant

N20.30-2049-01

3 Cap

4 Filler neck

Danger!

Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant.

Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.

Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

1

Check radiator, coolant lines, coolant pipes and coolant hoses of cooling and heating system for leaks and condition

AP20.00-I-2050B

2

Unscrew cap (3)

3

Open regulating valve of heating system

On vehicle without automatic heater: The temperature selector must be in the "max" position.
On vehicles with automatic heater:
The steering wheel lock must be engaged.

4

Drain coolant

The old coolant and the corrosion residues must be completely flushed out. If cooling system is very dirty:

AP20.00-I-2080-01B

Remove grease and scale in the cooling system

AR20.00-I-1030B

The statutory regulations or local wastewater regulations must be observed when disposing of coolant.

5

Pour in new coolant

Only use new coolant in the specified composition.

AP20.00-I-2080-01B

*BF20.00-N-1001-01C

Notes on coolant

AH20.00-N-2080-01A

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

6

Bleed cooling and heating system

To do this, allow the engine to run for approx. one minute with varying speed and in the process refill with coolant up to the bottom edge of the filler neck (4).

7

Screw on cap (3)

Engine cooling system

Number

Designation

Engine 904.941 in model 684

BF20.00-N-1001-01C

Coolant

Total filling capacity

L

19

Anticorrosion/antifreeze agent down to -37°C

L

9.5

Anticorrosion/antifreeze agent down to -45 °C

L

10.5

Specifications for Operating Fluids

Sheet

BB00.40-P-0310-01A

Sheet

BB00.40-P-0325-02A

Sheet

–

참조 문서