Model | 900 with engine 651 |
with code HZ5 (10 kW warm water auxiliary heater with timer) | |
Model | 900 with engine 651 |
with code HZ9 (Heater booster) | |
Model | 906 with engine 642, 646, 651 |
with code H12 (Auxiliary hot-water heater) | |
Model | 906 with engine 642, 646, 651 |
with code HZ5 (10 kW warm water auxiliary heater with timer) | |
Model | 906 with engine 642, 646, 651 |
with code HZ9 (Heater booster) |
D83.30-1203-08
1 | Electrical connectors | 3 | Fuel line | ||||
2 | Auxiliary heater (with support plate) | 4 | Coolant hoses |
Danger ! | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Danger ! | Risk of explosion caused by fuel vapors igniting, risk of poisoning caused by inhaling combustible gases and risk of injury caused by burns during and after operation of heater unit | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed rooms or when refueling. Allow heater unit to cool down after operation and wear protective gloves. | |
Danger ! | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
| Notes on coolant | ||
| Remove/install | ||
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
1 | Lift/jack up vehicle | ||
2 | Separate electrical connections (1) | Installation: Always make sure to connect the 8-pin plug last, as the auxiliary heater (2) is coded when power is supplied through the plugs. | |
3 | Remove coolant hoses (4) for auxiliary heater (2) from coolant lines on underfloor | Collect escaping coolant in a clean container, seal coolant lines. | |
Record plug | |||
4 | Remove fuel line (3) from fuel metering pump | Collect escaping fuel, seal fuel lines. | |
Record plug | |||
5 | Remove auxiliary heater (2) from underfloor | Nut, heater to cab floor | |
6 | Install in the reverse order | ||
7 | Adjust coolant to correct level | ||
| Engine cooling system - inspecting fluid level, adjusting to correct level | ||
| Check | ||
8 | Check auxiliary heater (2) for proper operation |
129 589 00 91 00
Record plug
参照文書
- ah2000n208001a クーラントについての注意事項
- ap2000d2011h エンジン·ク一リング·システムのク一ラント·レベルの点検、補充
- ar0060d1000h 車両リフト·アップ、ジャッキ·アップ
- as0000z001001a 車両がリフトから滑り落ちたり、傾くことによる生命の危険
- as2000z000101a 高温のクーラントが高圧で噴出して、皮フおよび目に火傷を負う危険があります。クーラントを誤飲すると、中毒になる危険があります。
- as4700z000101a 燃料が引火することによる爆発の危険、気化した燃料を誤って吸い込んだり、飲み込んだりすることによる中毒の危険、燃料が飛び散ることによる皮膚や眼の負傷の危険があり�
- as8370z000201a ヒ一タの作動中、あるいは作動後に、気化したフュ一エルによる爆発のおそれ、燃焼ガスを吸い込むことによる中毒のおそれ、および火傷を負うおそれがあります。