Model | 900 with engine 651 |
with code HZ5 (10 kW warm water auxiliary heater with timer) | |
Model | 900 with engine 651 |
with code HZ9 (Heater booster) | |
Model | 906 with engine 642, 646, 651 |
with code H12 (Auxiliary hot-water heater) | |
Model | 906 with engine 642, 646, 651 |
with code HZ5 (10 kW warm water auxiliary heater with timer) | |
Model | 906 with engine 642, 646, 651 |
with code HZ9 (Heater booster) |
D83.30-1203-08
1 | Electrical connectors | 3 | Fuel line | ||||
2 | Auxiliary heater (with support plate) | 4 | Coolant hoses |
Danger ! | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Danger ! | Risk of explosion caused by fuel vapors igniting, risk of poisoning caused by inhaling combustible gases and risk of injury caused by burns during and after operation of heater unit | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed rooms or when refueling. Allow heater unit to cool down after operation and wear protective gloves. | |
Danger ! | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
| Notes on coolant | ||
| Remove/install | ||
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
1 | Lift/jack up vehicle | ||
2 | Separate electrical connections (1) | Installation: Always make sure to connect the 8-pin plug last, as the auxiliary heater (2) is coded when power is supplied through the plugs. | |
3 | Remove coolant hoses (4) for auxiliary heater (2) from coolant lines on underfloor | Collect escaping coolant in a clean container, seal coolant lines. | |
Record plug | |||
4 | Remove fuel line (3) from fuel metering pump | Collect escaping fuel, seal fuel lines. | |
Record plug | |||
5 | Remove auxiliary heater (2) from underfloor | Nut, heater to cab floor | |
6 | Install in the reverse order | ||
7 | Adjust coolant to correct level | ||
| Engine cooling system - inspecting fluid level, adjusting to correct level | ||
| Check | ||
8 | Check auxiliary heater (2) for proper operation |
129 589 00 91 00
Record plug
Referenced documents
- ah2000n208001a Notes on coolant
- ap2000d2011h Engine cooling system - inspecting fluid level, adjusting to correct level
- ar0060d1000h Lift/jack up vehicle
- as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.
- as2000z000101a Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant.
- as4700z000101a Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel.
- as8370z000201a Risk of explosion caused by fuel vapors igniting, risk of poisoning caused by inhaling combustible gases and risk of injury caused by burns during and after operation of heater unit