S60.00-4576-06
1 | Screw |
2 | Lock striker |
3 | Covers |
4 | Bolts |
5 | Door stop |
6 | Bolts |
7 | Lock striker |
S60.00-4593-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.Model 447 with engine 780 | |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment | Model 447 with engine 780 | |
| Remove/install | ||
1 | Detach ground line of on-board electrical system battery. | ||
2 | Disconnect ground line of auxiliary battery. |
| |
3 | Remove ground line of auxiliary battery for ECO start/stop function. |
| |
Model 447 | |||
4 | Disconnect ground on additional battery for park pawl emergency shift. |
| |
5.1 | Remove liftgate. | Model 447 | |
5.2 | Remove left rear-end door and/or right rear-end door. | Model 447.6/7 | |
6 | Remove carrier for rear bumper. | ||
7 | Detach decoupling elements at rear muffler. |
| |
Do not remove the rear muffler. | |||
8.1 | Remove rear towing eye. | Model 447 | |
8.2 | Remove trailer hitch. | Model 447 | |
9 | Remove spare wheel holder. |
| |
10.1 | Release sealing frame of liftgate in repair area. | Model 447 | |
10.2 | Release sealing frame of the rear-end doors in the repair area. | Model 447.6/7 | |
11 | Remove rear-end center-section trim. |
| |
Model 447.6 | |||
12 | Remove lock striker (2). | Model 447, 448 | |
To do this, remove screw/bolts (1) . | |||
Bolt, lock striker to body | |||
13 | Remove covers (3). | Model 447.6/7 | |
14 | Remove door check (5). | Model 447.6/7 | |
For this purpose, remove bolts (4). | |||
15 | Remove lock strikers (7). | Model 447.6/7 | |
To do so, remove the bolts (6). | |||
Bolt, lock striker to crossmember | |||
16 | Install in the reverse order. |
Referenced documents
- ah0000z030001a General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment
- ar3110s8000e Remove/install trailer hitch
- ar4000s0100e Remove/install spare wheel holder
- ar4910s4823e Remove/install rear muffler
- ar5410s0003e
- ar5410s0003e Disconnect/connect battery ground line
- ar5410s0004e Disconnect, connect ground line of additional battery
- ar5410s0111e Remove/install additional battery for ECO start/stop function
- ar5410s0111ee Remove/install additional battery for ECO start/stop function
- ar5410s0120e Remove/install additional battery for park pawl emergency shift mode
- ar6420s1203e Remove/install rear tow eye
- ar6830s4785e Remove/install paneling on rear center section
- ar6830s4785ee Remove/install paneling on rear center section
- ar7220s1020e Remove/install liftgate
- ar7220s1901e Remove/install rear-end door
- ar7220s2120e Remove/install door frame seal of liftgate
- ar7220s2122e Remove/install sealing frame of rear-end door
- ar8820s2250e Remove/install carrier for rear bumper
- as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.
- as0000z003501a Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)