AP20.50-W-2003A | Rear cooling system fan drive - oil and filter change | 17.12.09 |
ENGINE 542.9 in MODEL 954 with CODE (MP1) Rear cooling system
N55.30-2059-06
1 Oil reservoir
2 Oil level indicator
3 Oil drain screw
4 Oil filler cap
5 Filter element
6 Oil filter housing upper part
7 Oil filter housing lower part
8 Oil filter element
9 Oil filter cover
W26.55-1017-11
F2-A27 Oil cooler fuse
K1-A37 Oil cooler relay
| Remove/install | ||
1 | Clean the area around oil filler cap (4), oil drain screw (3) and oil filter housing upper part (6) | ||
2 | Unscrew oil filter housing cap (9) | ||
3 | Unscrew oil drain screw (3) and drain oil from oil reservoir (1) | Collect oil with corresponding container. | |
| |||
4 | Pull out oil filter element (8) with oil filter housing lower part (7) through the oil filter housing upper part (6) | ||
5 | Pull oil filter element (8) out of oil filter housing lower part (7) | Installation: Replace oil filter element (8) and clean oil filter housing lower part (7). | |
6 | Remove filter element (5) of breather valve | Clean, check filter element (5) of breather valve, replace if necessary. | |
7 | Install in the reverse order | ||
8 | Unscrew oil filler cap (4) and pour in oil through the filler opening up to the center (arrow) of the oil level indicator (2) | Only pour in oil up to the max. center of the oil level indicator (arrow) otherwise when the semitrailer is connected the oil from the semitrailer may overfill oil reservoir (1) and escape from the overfilled oil reservoir (1). | |
Oil grade and oil reservoir volumes; see "Technical Data" adhesive label on oil reservoir (1). | |||
| Note to adhesive label "Specifications" for rear cooling system | ||
9 | Screw on oil filler cap (4) | ||
10 | Switch off oil cooler fuse (F2-A27). | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by jamming and burns when working on the engine while it is being started or when it is running | Secure vehicle to prevent it from moving by itself. Always wear appropriate work clothing when working on the vehicle. | |
11 | Shift manual transmission into neutral, start the engine and allow to run at approx. 1200 rpm for 2 to 3 minutes | This is necessary so that the hydraulic circuit of the rear cooling system is bled. | |
12 | Check oil level in oil container (1) at oil level indicator (2) | Correct oil level if required. | |
Oil grade and oil reservoir volumes; see "Technical Data" adhesive label on oil reservoir (1). | |||
| Note to adhesive label "Specifications" for rear cooling system | ||
13 | Turn off engine | ||
14 | Switch on fuse (F2-A27) |
Hydraulic drive
Referenced documents
- ah2050n000101a Note to adhesive label "Specifications" for rear cooling system
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.