Test and adjustment values
Number | Designation | Model | |||
BE60.00-P-1001-01M | Size of gap | CBS front end to headlamps | Dimension "A" | mm | 5.0 (2.5) |
CBS front to front engine hood | Dimension "B" | mm | 5.0 (1.5) | ||
CBS front to side engine hood | Dimension "C" | mm | 8.0 (1.5) | ||
CBS front to A-pillar | Dimension "D" | mm | 5.0 (1.0) | ||
CBS front to cover | Dimension "E" | mm | 3.0 (1.0) | ||
BE60.00-P-1002-01M | Size of gap | Engine hood to cover | Dimension "F" | mm | 4.0 (2.0) |
Cover to A-pillar | Dimension "G" | mm | 3.0 (1.0) | ||
BE60.00-P-1003-01M | Size of gap | Front door to A-pillar | Dimension "H" | mm | 8.0 (1.5) |
Front door to entry | Dimension "I" | mm | 8.0 (1.5) | ||
Front door to rear door | Dimension "J" | mm | 8.0 (1.5) | ||
BE60.00-P-1004-01M | Size of gap | Rear door entry | Dimension "K" | mm | 8.0 (1,5) |
Rear door to C-pillar | Dimension "L" | mm | 8.0 (1,5) | ||
BE60.00-P-1005-01M | Size of gap | CBS rear end to C-pillar | Dimension "M" | mm | 5.0 (1.0) |
CBS rear end to tailgate | Dimension "N" | mm | 7.0 (2.0) | ||
BE60.00-P-1006-01M | Size of gap | Rear door to C-pillar | Dimension "O" | mm | 6.5 (1.0) |
Rear door to taillamp | Dimension "P" | mm | 7.0 (1.0) | ||
Tailgate to side CBS rear end | Dimension "Q" | mm | 6.5 (2.0) | ||
BE60.00-P-1007-01M | Size of gap | Taillamp to rear spoiler | Dimension "R" | mm | 5.4 (1.5) |
Taillamp to C-pillar | Dimension "S" | mm | 3.0 (1.0) | ||
BE60.00-P-1008-01M | Size of gap | Roof to rear spoiler | Dimension "T" | mm | 6.5 (2.0) |
Feeler gage
452 589 01 21 00
P60.00-2311-05
Adjust hood, doors and trunk lid as shown in drawings. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 1.0 mm over the entire length.
If the inside clearance is too large or too small, the movable body parts must be centered accordingly.
The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2312-06
Adjust hood, doors and trunk lid as shown in drawings. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 2.0 mm over the entire length.
If the inside clearance is too large or too small, the movable body parts must be centered accordingly.
The reference measurements apply only for repair work on bodies damaged in accidents.