AR25.10-W-0050DA | Remove/install clutch | 19.3.07 |
MODEL 374, 375, 940, 942, 943, 944, 958 with ENGINE 457.9
with single-plate clutch
W25.10-1051-11
1 Clutch pressure plate unit
2 Screwdriving
3 Centering drift
W25.10-1046-09
4 Flywheel
5 Clutch plate (at engine end)
6 Intermediate ring with intermediate disk
10 Clutch operator with release bearing
11 Guide bearing
7 Clutch plate (at transmission end)
8 Clutch pressure plate
9 Bolt
Modification notes
1.9.06 | Before installation of the new clutch pressure plate check whether the diaphragm spring reeds are correctly seated into the clutch bearing, added. | Step 11 |
| Removing | ||
1 | Remove engine or transmission | Select the procedure according to the setup and accessibility. | |
2 | Install assembly device on clutch pressure plate unit (1) | ||
3 | Unscrew bolts (2), lift out clutch pressure plate unit (1) using the assembly device and remove clutch plate (5) at engine end | Loosen the bolts (2) in small stages diagonally in order to avoid a one-sided load on the clutch pressure plate unit (1). | |
4 | Remove assembly device | ||
5 | Check clutch parts for wear and damage | The clutch plates (5 and 7) may only be replaced together. | |
| Clean | ||
6 | Clean profile grooves in the clutch plate (5) at the engine end and clean hub profile of the transmission input shaft | The nickel plated hub surface of the clutch plate (5) must not be greased in order to avoid the clutch plate (5) jamming. | |
7 | Clean sliding sleeve in clutch operator with release bearing (4) and guide tube at transmission | ||
8 | Clean guide bearing (11) in flywheel (4) | ||
| Install | ||
9 | Slide the centering drift (3) into the guide bearing (11) in the flywheel (4) | | |
10 | Center the clutch plate (5) at the engine end on the flywheel (4) via the centering drift (3) | ||
11 | Install assembly device on clutch pressure plate unit (1) | Before installing the new clutch pressure plate unit (1) check whether the tongues of the diaphragm spring seat correctly in the clutch operator with clutch bearing (10). | |
12 | Install assembled clutch pressure plate unit (1) with the assembly device over the centering drift (3) | A new clutch pressure plate unit (1) is supplied adjusted. | |
13 | Tighten the bolts (2) in small stages in a crosswise pattern | While tightening ensure that centering drift (3) can still be moved easily. | |
| |||
14 | Remove assembly device | ||
15 | Remove centering drift (3) | ||
16 | Install engine or transmission | ||
17 | Connect STAR DIAGNOSIS | ||
18 | Teach in clutch travel anew in the drive control (FR) control unit | Only on vehicles without code (GE3) Mercedes PowerShift. | |
19 | Teach in gear control (GS) control unit | Only on vehicles with code (GS2) gear control or with code (GE3) Mercedes PowerShift when the clutch pressure plate unit (1) or the two clutch plates (5, 7) have been replaced. | |
Vehicles with code (GS2) Gear control | |||
Vehicles with code (GE3) Mercedes PowerShift | |||
20 | Disconnect STAR DIAGNOSIS |
Clutch
Centering drift
950 589 00 61 00
Henviste dokumenter
- ar2510w0051da
- ar5421w0007a
- ar5421w0009a Programmering af styreenhed gearstyring (GS)