ar2010p1271mro

Remove/install coolant pump

Type ar · emne 20.10 · version 0100 · 2020-07-14

Gælder for: Engine 264 in model 463

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 20 Motorkøling › 20.10 Kølevæskepumpe, kølevæsketermostat — Serie 463

EinPAS 15 Motor › 15.25 Motorkølesystem › 15.25.30 pumpe/termostat/forvarmningsapparat — Serie 463

Gælder også for motorer/gearkasser: 264 ***

AR20.10-P-1271MRO

Remove/install coolant pump

18.05.2020

Engine

264 in model 463

Remove/install coolant pump

1

Coolant thermostat

2

Coolant hose

P20.10-A073-05

Remove/install coolant pump

P20.10-A074-08

3

Coolant pump

5

Bracket

4

Screw

6

Bolts

Warning

Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant.

Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.
Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

Topical note

Notes on coolant

AH20.00-N-2080-01A

Topical note

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove/install

1

Remove coolant thermostat (1).

AR20.10-P-2461MRO

2

Remove coolant hose (2) from coolant pump (3), place to one side and seal.

Hose clamp pliers

*454589003700

Record plug

*129589009100

3

Remove brackets of electrical wiring harness from coolant pump (3).


Do not crush or kink or subject lines to tension.
This would lead to damage to the lines and can impair their function.

Dismantling tool

*000589956300

4

Release and disconnect electrical connector.

5

Remove screws (4) and remove bracket (5).

Topical note

Notes on threaded connections fastened using a tightening angle-based tightening process

AH00.00-P-0020-01A

Bolt, support to support/exhaust gas turbocharger

*BA09.40-P-1012-02C

6

Remove screw/bolts (6).

Bolt, coolant pump to crankcase/oil pan

*BA20.10-P-1001-01CA

7

Remove coolant pump (3).

8

Install in the reverse order.

Turbocharger

Number

Designation

Engine 264

BA09.40-P-1012-02C

Bolt, support to support/exhaust gas turbocharger

Stage 1

Nm

15

Stage 2

°

90

Coolant pump, coolant thermostat

Number

Designation

Engine 264

BA20.10-P-1001-01CA

Bolt, coolant pump to crankcase/oil pan

Nm

20

Remove/install coolant pump
Remove/install coolant pump
Remove/install coolant pump

000 589 95 63 00

Dismantling tool

454 589 00 37 00

Hose clamp pliers

129 589 00 91 00

Record plug

Henviste dokumenter