ar2010g2460ne

Removing/installing the coolant thermostat

Type ar · emne 20.10 · version 0100 · 2004-06-01

Gælder for: ENGINE 902.912 in MODEL 405.210 /230 for USA/Canada only

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 20 Motorkøling › 20.10 Kølevæskepumpe, kølevæsketermostat — Serie 405 (modeller 210, 230) · Serie 902 (modeller 912)

EinPAS 15 Motor › 15.25 Motorkølesystem › 15.25.30 pumpe/termostat/forvarmningsapparat — Serie 405 (modeller 210, 230) · Serie 902 (modeller 912)

AR20.10-G-2460NE

Removing/installing the coolant thermostat

25.3.04

ENGINE 902.912 in MODEL 405.210 /230
for USA/Canada only

Removing/installing the coolant thermostat
Removing/installing the coolant thermostat

G20.10-3118-01

1 Coolant hose

2 Housing cover of coolant thermostat

3 Bolts

4 Coolant thermostat

5 O-rings

G20.10-3119-01

Remove/Install

Danger!

Risk of injury caused by body parts being jammed and crushed when tilting cab

Ensure that no one is within the tilting range of the cab during tilting. Always tilt the cab all the way to the end position and secure with the safety strut.

AS60.80-Z-0001-01A

1

Tilt cab

AR60.80-G-0010NA

Notes on tilting cab

Model 405.210/230 with body 405.830

AH60.80-N-0003-01NA

Danger!

Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant.

Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles.

Wear protective gloves, protective clothing and eye protection.

AS20.00-Z-0001-01A

2

Drain and collect coolant

Installation: Pour in the coolant; refer to maintenance instructions .

Notes on coolant

All engines

AH20.00-N-2080-01A

3

Detach the coolant hose (1) at the coolant thermostat housing cover (2)

Collect coolant which flows out

4

Remove screws (3)

*BA20.10-N-1007-01M

5

Remove the coolant thermostat housing cover (2)

Installation: install new O-rings (5).

6

Remove both the coolant thermostats (4)

Installation: Pay attention to the installation position of the coolant thermostats (4).

7

Test coolant thermostat (4)

AR20.10-G-2455NA

8

Install in the reverse order

9

Check coolant level and correct if necessary

Refer to the maintenance instructions .

10

Inspect cooling system for leaks

Coolant pump, coolant thermostat

Number

Designation

Engine
902.912

BA20.10-N-1007-01M

Bolt of the coolant thermostat housing cover

Nm

25

Henviste dokumenter