P18.20-2130-09
1 | Exhaust intermediate pipe | 2l | Steering gear heat shield | ||||
2 | Integral carrier heat shield | 3 | Right side shaft heat shield |
9 | Wide open throttle bleed line |
10 | Screw/bolt |
11 | Oil separator |
P01.20-2345-12
4 | Vent line |
5 | Screw/bolts |
6 | Coolant return line |
7 | Purge lines |
8 | Bracket |
9 | Wide open throttle bleed line |
P01.20-2344-05
| Remove/install | ||
1 | Remove lower engine compartment paneling | ||
2 | Empty low-temperature circuit | ||
3 | Remove exhaust intermediate pipe (1) | ||
4 | Remove integral carrier heat shield (2) | ||
5 | Remove right side shaft heat shield (3) | ||
6 | Remove screw/bolt (10) and detach wide open throttle vent line (9) from crankcase | Installation: Replace sealing ring. | |
Bolt, crankcase ventilation system vent line to crankcase | |||
7 | Remove charge air hose | ||
8 | Detach coolant return line (6) at charge air cooler | ||
9 | Remove screws/bolts (5) at coolant return line (6) | ||
10 | Detach vent line (4) at coolant expansion reservoir for low-temperature circuit and provide with coolant return line (6) to one side | ||
11.1 | Detach wide open throttle vent line (9) from oil separator (11) | Engine 133 in model 117, 156, 176 | |
11.2 | Remove oil separator | Engine 133 in model 117, 156, 176 | |
The wide open throttle vent line (9) and the oil separator (11) are firmly connected together over a key-lock connection. Therefore the oil separator (11) and the wide open throttle vent line (9) must be replaced after disconnection of the connection. | |||
12 | Detach purge lines (7) from wide open throttle vent line (9) and place somewhat to one side | | |
Installation: Install new sealing rings. | |||
13 | Detach wide open throttle vent line (9) from bracket (8) | ||
14 | Unclip wide open throttle vent line (9) at cylinder head cover and remove upwards | Installation: Pay attention to correct routing of wide open throttle vent line (9). | |
15 | Install in the reverse order | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
16 | Carry out engine test run and check engine for leaktightness while it is running |
Henviste dokumenter
- ar0120p9750mta
- ar0941p8619mta
- ar2000p1144mta
- ar4910p7100mta
- ar6120p1105nkb
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører