Engine | 904 in model 688.232/244/254/255, 979.046/048 |
Engine | 904 in model 693.103/171/185/186, 694.000/020/042 |
Engine | 906 in model 693.148/348/386/396, 695.010/011/304 |
Engine | 924 in model 694.000/042, 695.010/011/304 |
Engine | 924 in model 979.023/026/028/073/076/078 |
Engine | 926 in model 693.298/328/388, 695.010/011/304 |
1 | Cover |
2 | Seal ring |
3 | Filter element |
4 | Dirt collector |
5 | Housing filter |
B07.00-0002-01
B07.00-0003-01
For vehicles with advanced cab |
S10 | Starting switch |
S11 | Stop switch |
B01.00-0008-01
| Remove | ||
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
1.1 | Tilt the cabin | Advanced cab | |
Warning | Risk of injury caused by pinching and crushing when opening and closing engine hood | No one should be within the swivel range of the engine hood as it is being opened or closed. Always open engine hood all the way to the end position until this engages in the front locks. | |
1.2 | Tilt the engine hood | Semi-advanced cab | |
Access to carry out maintenance and repair work, varies with body type/make. Refer to the body builder instructions | |||
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
2 | Unscrew the cap (1), remove it together with the filtering element (3), from the dirt collector (4) | When unscrewing the cover (1), the fuel will flow to the reservoir, through the return pipe. | |
3 | Remove the dirt collector (4) from the filter housing (5) | Pay attention and avoid the dirt getting inside the oil filter housing. Do not clean the dirt collector (4) in the oil filter housing. Do not wash the filter housing. | |
4 | Clean the dirt collector (4) and the threaded cap (1) | ||
| Install | ||
5 | Install the new sealing ring (2) | Oil the sealing ring with clean engine oil. | |
6 | Install a new filtering element (3) in the cap (1) | ||
7 | Install the dirt collector (4) on the filter housing (5) | Observe the correct assembly position. | |
8 | Install the cap (1) together with the filtering element (3) | .Cover on the fuel filter housing | |
9 | Bleed the fuel system |
| |
Act on the handle of the hand primer pump until strong resistance is observed. | |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
10 | Start the engine and check the fuel system for tightness | On vehicles with advanced cab, start the engine through the starter switch (S10). | |
Do not crank the engine continuously for more than 30 seconds. If the engine does not fire within this interval, wait approximately 1 minute to crank it again. | |||
11 | Stop the engine | On vehicles with advanced cab, stop the engine through the stop switch (S11). | |
12.1 | Return the cab to the normal position | Advanced cab | |
12.2 | Close engine hood | Semi-advanced cab |
Henviste dokumenter
- ap4700b172001c
- as0000z000501a Fare for ulykke ved automatisk igangsætning når motoren kører. Fare for personskade på grund af knusning og forbrænding, hvis der arbejdes mens motoren startes eller kører
- as4700z000101a Fare for eksplosion ved tænding, fare for forgiftning ved indånding og indtagelse af brændstof samt fare for hud- og øjenskader ved kontakt med brændstof
- as6080z000101a Fare for personskade ved fastklemning og knusning, når førerhuset tippes
- as8840z000101a Fare for personskade på grund af fastklemning og knusning ved åbning og lukning af motorhjelm