Shown on model 171.442 |
2 | Power steering oil line |
3 | Screw |
4 | Power steering oil line |
5 | Front axle carrier |
6 | Screw |
Y10 | SPS [PML] solenoid valve |
P33.10-2162-06
Illustrated on model 172 |
2 | Power steering oil line |
3 | Screw |
P33.10-2363-04
P33.10-2219-08
Shown on model 171.442 |
1 | Diagonal strut | 7 | Screw | 9 | Screw | ||
5 | Front axle carrier | 8 | Screw |
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Notes on self-locking nuts and bolts | ||
| Notes on repair work on suspension components | ||
| Remove/install | ||
1 | Open engine hood | ||
2 | Mount engine hoist |
| |
Model 171 with engine 272 | |||
Engine lifting device | |||
3 | Disconnect lower steering shaft at steering coupling | ||
4 | Remove diagonal struts (1) | Installation: Only tighten the screws/bolts of the diagonal struts when the vehicle is in a ready-to-drive condition. | |
Self-locking bolt, front diagonal strut to frame floor or front axle carrier | |||
5 | Remove screw/bolt (3) and detach oil line of power steering (2) from oil pan | Model 171 | |
Model 171 with engine 271Bolt, power steering oil line to oil pan | |||
Model 171 with engine 272Screw/bolt, power steering pressure line to oil pan | |||
Model 172 with engine 271, 276, 651Bracket, high-pressure line/low-pressure line to oil pan | |||
6 | Remove bolt (6) and detach oil line of power steering (4) from front axle carrier (5) | Model 171Bolt, power steering oil line to front axle carrier | |
Model 172 with engine 271, 276, 651Bolt, high-pressure line to major assembly carrier | |||
7 | Disconnect plug from SPS solenoid valve (Y10) and detach electrical line from front axle carrier (5) | Model 171 | |
8 | Remove bolts (7) | Model 171, 172 | |
Model 171 with engine 271, 272Screw/bolt, front engine mount to front axle carrier | |||
Model 171 with engine 113Bolt, front engine mount to front axle carrier | |||
Model 172Bolt, front engine mount to front axle carrier | |||
9 | Support front axle carrier (5) using telescopic lifter and transmission plate | ||
| 000 588 11 62 00 Major assembly mount | ||
10 | Remove screws/bolts (8, 9) | ||
| Notes on bolted connections with self tapping screws | ||
| |||
The screws/bolts (8, 9) are self-tapping screws. | |||
Never re-tap thread in longitudinal member. | |||
Installation: Replace screw/bolts (8, 9). | |||
Screw/bolt, front axle carrier to longitudinal member | |||
11 | Lower front axle carrier (5) | | |
12 | Install in the reverse order | Installation: Only tighten the nuts and bolts of the suspension components when the vehicle is in a ready-to-drive condition. | |
13 | Perform wheel alignment check |
| |
Model 172 |
240 589 00 61 00
Engine lifting device
Odkazované dokumenty
- ah0000n000101a Upozornění k samopojistným šroubům a maticím
- ah0000p000701sf Upozornění ke šroubovým spojům se samotvarovatelnými šrouby
- ah0000p010001a Pokyny k opravárenským pracím na komponentech podvozku
- ar3310p010001v
- ar3310p010001va
- ar3310p010003v
- ar4020p0200ew Provedení měření podvozku
- ar4020p0200v
- ar4610p8000v
- ar8840p1000v
- as0000z001001a Nebezpečí ohrožení života v případě sesunutí nebo překlopení vozu z dílenského zvedáku
- ws0100p0092b