0116 - Adjustment of start of delivery (position sensor RIV method) after check Engines 601, 602.91, 603.91 (note deviations for off-road vehicles) · ra07016010116x · Mercedes-Benz WIS

07.1-116 Adjusting start of delivery (position sensor RIV method) -
after check

Job no. of Job Texts and Work Units or Standard Texts

and Flat Rates 07-8300

0116 - Adjustment of start of delivery (position sensor RIV method) after check
Engines 601, 602.91, 603.91 (note deviations for off-road vehicles)

Crankshaft	turn in direction of rotation to 15° ATDC of cylinder 1. Vehicles with code 62/0 14° ATDC.
Loosen mounting screws (13 and 13a) on the injection pump flange and support bracket	tightening torque 20-25 Nm.
Indicating instrument (008) and crocodile clamp (009)	connect to B+.
Pivot injection pump by turning the adjusting screw at the adjusting device for start of delivery (8)	both lamps "A and B" must light up in the indicating instrument (008).
Direction of rotation of the adjusting screw Right = start of delivery retarded Left = start of delivery advanced	RI set value 15° ATDC. Vehicles with code 62/0 14° ATDC.
Position sensor (007)	remove.
Screw plug (11)	turn in.
Control linkage	check, adjust if required (30-300).
Leak test with engine running	carry out.
Engine oil level	check, correct.

Note
Before adjustment, check start of delivery
(07.1-111).

Adjusting

-------------------------------

1 Turn crankshaft in direction of rotation to 15° ATDC of 1st cylinder.
Vehicles with code 62/0 14° ATDC.

2 Loosen mounting screws (arrows) on injection pump flange and support bracket (arrow).

Screw on support bracket

3 Connect indicating instrument (008) and crocodile clamp (009) to battery plus.

4 Pivot injection pump by turning the adjusting screw on the start of delivery adjusting device until both lamps light up.

Direction of rotation of the adjusting screw

Right = retarded start of delivery
Left = advanced start of delivery

RI set value: 15°1° ATDC

Vehicles with code 62/0 14°+0.5° ATDC.

Note
If the adjusting range is inadequate, the injection pump must be repositioned. Injection pump, remove, reinstall (07.1-200).

5 Secure mounting screws on injection pump flange and support bracket, tightening
torque 20-25 Nm.

6 Remove position sensor.

7 Turn in screw plug, tightening
torque 30-35 Nm.

8 Check control linkage and adjust if
required (30-300).

9 Carry out leak test with engine running.

10 Check engine oil level and correct if required.

0116 - Adjustment of start of delivery (position sensor RIV method) after check Engines 601, 602.91, 603.91 (note deviations for off-road vehicles)

เอกสารที่อ้างถึง